All specications subject to change without notice. Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
COMBINATION INSTALLATIONS
DR30EI[F]S Range with ERV3015
Raised Vent
Document # PGCI-027 Revised 10/15/12 Page 1/1
All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted.
■Only models DR30EIS and DR30EIFS may be installed with a raised
vent. Use only Dacor raised vent model ERV3015.
■A self-rimming countertop configuration is required for raised vent
installation. On installations with a raised vent, when sliding the range
into position, it will stop when the rear of the control panel or side
panels contact the notches toward the front of the countertop.
■The self-rimming installation of the DR30DI range and ERV3015
raised vent create a “built-in” look where the range trim overlaps the
countertop on both sides and the raised vent overlaps the countertop
in back.
* To create a “built-in look” on the front of the cabinet, this dimension may be changed to 29 1/4” (74.3 cm), with the width at the notches remaining 30
1/16”. This configuration is only for models DR30EIS and DR30EIFS with side panels behind door removed.
TOP VIEW - DOWNDRAFT ERV30[15] WITH SLIDE-IN, SELF-RIMMING INSTALLATION USING
3” SIDE PANELS REMOVED
TOP VIEW - DOWNDRAFT ERV30[15] WITH SLIDE-IN, SELF-RIMMING INSTALLATION USING
3” SIDE PANELS INSTALLED
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
raised vent opening
27 1/2” (69.9 cm)
30 1/16” (76.2 cm)
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (1.0 cm)
countertop overhang
10” min. (25.4 cm)
to any combustibles
above counter both sides
19 3/4”
(50.2 cm)
to
22 3/4”
(57.8 cm)
19 3/4”
(50.2 cm)
2 5/8” (6.7 cm)
24 3/8”
(61.9 cm)
max.
Countertop front
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
raised vent opening
27 1/2” (69.9 cm)
30 1/16” (76.2 cm)*
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (1.0 cm)
countertop overhang
10” min. (25.4 cm)
to any combustibles
above counter both sides
22 3/4”
(57.8 cm)
2 5/8” (6.7 cm)
24 3/8”
(61.9 cm)
max.
Countertop front
Countertop height: 34 3/4” (88.3 cm) min.
36 7/8” (93.7 cm) max.
Countertop thickness: 1 5/8” (4.1 cm) max.
Cabinet face
Countertop
Range trim resting
on countertop
DR30EI[F]S range
3/8” min. (1.0 cm)
flat countertop
overhang
25 9/16” (64.9 cm)
ERV3015
raised vent
3/8” min. (1.0 cm) space
required behind ERV3015
chassis to clear stiffener
Cabinet face
Countertop
Range trim resting
on countertop
Back of
side panel
rests against
cabinet face
DR30EI[F]S range
3/8” min. (1.0 cm)
flat countertop
overhang
25 9/16” (64.9 cm)
3 inch
side panel
ERV3015
raised vent
3/8” min. (1.0 cm) space
required behind ERV3015
chassis to clear stiffener
