Dakota Digital RTX-65F-MUS User manual

Manual # 650707
RTX-65F-MUS
Dakota Digital RTX Instrument Installation
For 1965 Ford Mustang - GT and Pony style interiors only
1966 Ford Mustang - All interiors
Your new RTX-65F-MUS kit includes:
Installation
Control Box
Main Harness
Universal Sender
Pack
Installation Manuals
RTX Display
1. Remove the stock gauge cluster from the dash. This hardware will be re-used.
Ford Speed Adapter
Buzzer
(8) 6-20x1/2” Screws
Switch
Assembly

Manual # 650707
2. Remove the eight (8) screws holding the gauges to the bezel on the back of the system so the stock
gauges and lens can be removed from the bezel. The only item to be reused is the original front
bezel.
4. Secure the RTX system to the bezel with the eight provided screws
3. Test fit the RTX system into your bezel. If it fits properly, please move on to step 4.
•There are two variations of the 65’-66’Mustang bezel. One has a “Hi”center speedo gauge
and the other has a “Lo”center speedo gauge. If the large round center speed gauge doesn’t
fit properly into your bezel please remove the (4) screws shown below. Slide the center
speedo gauge to either “Hi”or “Lo”to fit your bezel. Replace the (4) screws and tighten until
snug.

Manual # 650707
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
6. Re-install the cluster into the vehicle and refer to the main manual for wiring instructions to complete
the RTX installation.
5. Connect the provided main harness and the buzzer (optional for audio feedback) to the back
of the RTX system.
Buzzer
Connector