DAMSON S-CUBE User manual

USER GUIDE
S-CUBE
damsonglobal.com

(M) Power/Mode (BT/Aux/JSN),
Vol –, Vol +, Play/Pause.
1. JetStreamNet Pairing,
2. Trangle,
3. Circle,
4. Square
5. Reset,
6. AUX In,
7. AC/DC Input
1.
2.
5.
6. 7.
3. 4.
Representation of LED lights
Red Flashing
when the cube is powered on and charging
Solid Red
when the cube is charging but powered off.
Solid Indiego
when the cube is connected to the JetStreamNet
Solid dark blue
when connected in Bluetooth mode
(this is the master cube only)
Blink red and colour
of mode the system is in
when the cube is powered on and
until fully charged.

1. Individual
Stereo Speaker
DC
AUX
Insert a cable into the AUX
port for wired connectoin.
The LED will light up yellow.
If selecting BT pair your
device to Damson
S-Cube. Function mode
should be set to Circle
2. Multi Speaker
1
DC
3
3
Select a primary speaker to
connect to your device to
S-Cube. Power on additional
speakers and change
function to JetStreamNet
mode (light blue LED).
Bring the additional speakers close to the primary speaker
and short press and hold the JSN Pairing button on
both speakers at the same time. Speakers are now
connected. Repeat for up to 16 speakers.
Change the output of each speaker. Select Triangle for
Stereo left channel and Square for Stereo Right channel,
or circle on each device if you wish to play stereo on each
speaker.
3. S-Series Surround - Establishing a
connection and reconnecting
Power On the
S-Woofer with remote
control.
Change the mode
on the S-Cubes to
JetStreamNet (light blue).
Short press the Pairing button on the S-Cube and
the JSN button on the remote control at the same
time, pressing for less than 3 seconds.
XBASS
Power Mute
1
1
2
3
On the left surround
speaker change the output
switch to triangle.
4
On the right surround
speaker change the output
switch to square.
5
DC
S-Cube has three primary functions:
2
DC
Speaker 1 Speaker 2
short press short press
DC
Power on and change mode
to either BT (Blue LED) or
2
Volume Pair
Previous Next
short press