Danby DPAC120090 Assembly instructions

Owner’s Use and Care Guide
Guide d'utiliser et soins de propriétaires
Danby Products Limited, PO Box 1778, Ontario, Canada N1H 6Z9
Danby Products Inc., PO Box 669, Findlay, Ohio, USA 45839-0669
Version 1.10.08 JF
Model • Modèle • DPAC120090
CAUTION:
Read and follow all
safety rules and
operating
instructions before
first use of this
product.
MISE EN GARDE:
Veuillez lire
attentivement les
consignes de
sécurité et les
directives
d’utilisation avant
l’utilisation initiale
de ce produit.
Portable Home Comfort
Important Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Part Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Care and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Appareil De Confort Au Foyer Portable
Renseignements Important sur la Sécurité . . . . . . . . . . . . . . . . . . . . . . . 12
Identification de Partie . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Instructions D’installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Consignes D’utilisation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
La Télécommande . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Soins et Entretien . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Dépannage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Garantie . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22

READ ALL SAFETY INFORMATION BEFORE USING
1) All wiring must comply with local and national
electrical codes and be installed by a qualified
electrician. If you have any questions regarding
the following instructions, contact a qualified
electrician.
2) Check available power supply and resolve
any wiring problems BEFORE installation and
operation of this unit.
3) This appliance draws 11.8 nameplate amps
under Cooling Mode and may be used in any
properly wired, general purpose 15 amp
household grounding receptacle
4) For your safety and protection, this unit is
grounded through the power cord plug when
plugged into a matching wall outlet. If you are
not sure whether the wall outlets in your home
are properly grounded, please consult a
qualified electrician. DO NOT USE PLUG
ADAPTERS OR EXTENSION CORDS WITH
THIS UNIT. If it is necessary to use an
extension cord with this unit, use an approved
“air conditioner” extension cord only (available
at most local hardware stores).
5) The manufacturer’s nameplate is located on
the rear panel of the unit and contains electrical
and other technical data specific to this unit.
6) To avoid the possibility of personal injury,
always disconnect the power supply to the unit
before installing and/or servicing.
TABLE 1
Suggested Individual Branch Circuit
Nameplate Amps *AWG Wire Size
11.8 14
AWG- American Wire Gauge
*Based on copper wire at 60°C temperature rating.
TABLE 2
Receptacle and Fuse Types
Rated Volts 125
Amps 15
Wall Outlet
Fuse Size 15
Time Delay Fuse Plug Type
(or Circuit Breaker)
1
IMPORTANT SAFETY INFORMATION
ELECTRICAL
SPECIFICATIONS
CAUTION: Do not leave this unit
unattended in a space where people or
animals cannot react to a failed unit are
located. A failed unit can cause extreme
overheating or death in such an
enclosed, unattended space.
POWER SUPPLY
CORD The power supply cord contains a current device that senses damage to
the power cord. Do the following to test your power supply cord:
1) Plug in the unit.
2) The power supply cord has two buttons on the plug head. Press the TEST button; you will
hear a click as the RESET button pops-out.
3) Press the RESET button; again you will hear a click as the button engages.
4) The power supply cord is now supplying electricity to the unit (on somoe products this is also
indicated by a light on the plug head).
NOTE:
• Do not use this device to turn the unit on or off.
• Always make sure the RESET button is pushed in for correct operation.
• The power supply must be replaced if it fails to reset when either the TEST button is pressed,
or if the device cannot be reset.
• If the power supply cord is damaged, it cannot be repaired and must be replaced.

• Use the unit in rooms of the recommended size.
• Locate the unit where furniture cannot obstruct air flow
• Keep blinds/curtains closed during the sunniest part of the day.
• Keep the unit’s air filter clean.
• Keep doors and windows closed to keep cool air in and warm air outside.
2
IMPORTANT SAFETY INFORMATION (cont’d)
SAFETY
PRECAUTIONS
To prevent injury to the user and other people, and to prevent property
damage, the following instructions must be followed. incorrect operation
due to ignoring these instructions may cause harm or damage.
ALWAYS DO THE FOLLOW:
• This unit should be used in such a way that it is protected from moisture; for example,
condensation, splashed water, etc. Do not place or store the unit where it can fall or come into
contact with water or other liquids.
• Always transport the unit in its upright position, and stand it on a stable, level surface during
use.
• Always use the switch on the control panel to start or stop the unit.
• Turn off the unit when it is not in use.
• Always contact a qualified service technician to carry out repairs.
• Keep at least 30cm (1 foot) of free space around the unit (e.g. from walls, furniture, etc.) to
allow for proper air circulation.
NEVER DO THE FOLLOWING
• Do not operate your air conditioner in a wet room, such as a bathroom or laundry room.
• Do not touch the unit with wet or damp hands or when barefoot (i.e. without socks on).
• Do not press the buttons on the control panel with anything other than your fingers.
• Do not remove any fixed covers. Never use this appliance if it is not working properly or if it
has been dropped or damaged.
• Do not cover or obstruct the inlet or outlet grills.
• Do not use hazardous chemicals to clean, or allow them to come in contact with, the unit. Do
not use the unit in the presence of flammable substances such as alcohol, insecticides, gas,
petrol, etc.
• Do not allow unsupervised operation of the unit by children.
• Do not use this product for functions other than those described in this manual.
ENERGY-SAVING
TIPS
OPERATING
CONDITIONS The unit must be operated within the following temperature ranges:
MODE TEMPERATURE
Cool 17°C - 32°C (62°F - 92°F)
Dehumidify 13°C - 32°C (54°F - 92°F)
Heat 5°C - 30°C (41°F - 88°F)

3
PART IDENTIFICATION
ACCESSORIES
Check to ensure that all accessories are included in the package (Fig. A). Please refer to
installation for their usage
Description Quantity
1) Intake / Exhaust Hose (with collars) 2 / set
2) Wall Intake / Exhaust Adapter A 2 / set
3) Window Intake / Exhaust Adapter B 2 / set
4) Expansion plug & screws 4 / each
5) Window / Patio Slider Kit 1 / set
from 67.5cm (26 1/2“) up to 210cm ( 82 1/2”)
6) Foam Seal 3 pcs
7) Remote Control 1 pc
8) Batteries 1 / set
1
2
3
4
5
6
7
8
Fig. A
UNIT PARTS
IDENTIFIED
FRONT
1) Control Panel
2) Louver Adjustment Handle
3) Vertical Louver Blades
4) Horizontal Louver Blades
5) Carrying Handles (both sides)
6) Castors (4)
1
2
3
4
5
6
Fig. B
REAR
1) Air Filter
2) Air Inlet
3) Air Outlet
4) Upper Drain Outlet
5) Vent Control
6) Power Cord Hooks
7) Lower Drain Outlet
CLOSE
OPEN
1
23
4
5
6
7
Fig. C

4
LOCATION
30cm/
1 ft
30cm/
1 ft
Fig. D
• The air conditioner should be placed on a firm
foundation to minimize noise and vibration. For safe
and secure positioning, place the unit on a smooth,
level floor that is strong enough to support the unit.
• The unit has castors to aid placement, but if
should only be rolled on smooth, flat surfaces. Use
caution when rolling on carpet surfaces. Do not
attempt to roll the unit over any objects.
• Never place any obstacles around the air inlet or
outlet of the unit.
• Give at least 30 cm (1 ft) of free space between
the wall and the unit to allow for efficient
air-conditioning.
WINDOW KIT
INSTALLATION
The window kit has been designed to fit most standard “vertical” and “horizontal” window
applications; however, it may be necessary to improvise or modify some aspects of the
installation procedures for unique window types.
Horizontal Windows: Minimum & Maximum Vertical Windows: Minimum & Maximum
Horizontal
window
Window Slider Kit:
Minimum: 67.5cm (2.22ft)
Maximum: 123cm (4.04ft)
Fig. E
Vertical
window
Window Slider Kit:
Minimum: 67.5cm (2.22ft)
Maximum: 123cm (4.04ft)
Fig. F
NOTE: If the window opening is less than the stated minimum length of the window slider kit,
cut the exhaust slider (the one with the oval shaped hole) shorter in order to fit it to the
window. If you are going to cut, do not compromise the integrity (shape) of the factory cut hole
in the slider, as this would make proper ventilation impossible.
INSTALLATION INSTRUCTIONS