Danfoss Icon Master User manual

VUMBB102 © Danfoss | FHH | 2016.09 | 1
User Guide
Danfoss Icon™Display
Room Thermostat, 230 V
Danfoss Icon™ Display is a room thermostat especially designed for floor heating systems. It comes in
four different designs to suit markets worldwide.
Danfoss Icon™ Display is very intuitive and easy to use. Just set your desired comfort temperature, and
the thermostat will control the room temperature in accordance with your setting.
Introduction
Wake up
the thermostat
Touch the screen to wake up Danfoss Icon™ Display.
The actual room temperature is displayed. The Heating icon is dis-
played, if the thermostat has turned on the heat.
Touch to return to the previous screen.
The screen turns off after 10 seconds without any action.
Set the temperature Wake up the thermostat
Touch or to set the desired room temperature.
The temperature flashes to indicate setting is in progress.
Confirm your setting by touching .
Reset to default
factory settings
Press and simultaneously for at least 3 seconds to reset Danfoss Icon™ Display to the default
factory settings.
The display toggles between and .
Confirm by touching .

2 | © Danfoss | FHH | 2016.09 VUMBB102
Danfoss A/S
Floor Heating Hydronics • Ulvehavevej 61 • DK-7100 Vejle • Denmark • Phone: [phone] • Fax: [phone]
[e-mail] • www.floorheating.danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Wake up the thermostat.
Press for 3 seconds to open the User menus and .
Toggle the menus with or .
Choose menu with .
(To open the Installer menus and , press again for 3 seconds).
Temperature limitation
and toggles with the temperature on the screen. Set highest temperature with or .
and toggles with the temperature on the screen. Set lowest temperature with or .
Confirm your choice with .
Default temperature range: 5 to 35° C.
Product ID
Production code.
Menu 3 and 4 are only relevant for the installer
Set actuator type
Choose between Normally Closed or Normally Open with or .
Confirm with .
Set heat emission characteristics of the floor
Choose Fast , Medium or Slow heat emission characteristics with or .
Confirm with .
Menus