en
it
de
es
fr
nl
pt
da
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh
-
pressure of the water supply is higher, a
pressure reducer must be installed.
clean water.
coverage to protect from weathering, in
order to preserve the cooler over time.
or adjust the cooler and the electricity or
water supply after installation, if it is not
air vents of the cooler, in order to pre-
-
age, do not let dust, dirt or other materi-
als come into contact with the cooler.
with ambient temperatures between
-
-
downs, when the temperatures drop to
and the pipes that supply water to the
cooler.
you handle or service the cooler (use
personal protective equipment in order
-
aged, it must be replaced by a technical
support centre to prevent any risk.
-
tential damage caused by the movement
of vehicles, pedestrians, weathering and
heat sources.
-
tions, disconnect the power supply and
contact the technical support centre.
supply, when it is not used for a medium
to long term period.
tank must come from an aqueduct. If it is
not possible to draw from an aqueduct,
the water introduced must be subjected
to a sanitation treatment, according to
-We recommend using water with a hard-
-The cooler tank must be emptied and
sanitised periodically depending on the
use.
-The cooling pad surfaces must be pe-
riodically inspected and sanitised de-
pending on the use.
-
ucts that comply with European regula-
►►2. UNPACKING
IMPORTANT: IT IS STRICTLY FORBIDDEN
TO STACK TWO OR MORE COOLERS.
2.1. Remove all packaging material used to
pack and deliver the cooler and dispose of it
in compliance with current standards.
2.2. Remove all items from the packaging.
2.3. Check for any damage incurred during
transport. If the cooler appears damaged,
immediately inform the dealer from whom it
was purchased.
►►3. ASSEMBLY AND INSTALLA-
TION (ONLY FOR QUALIFIED PER-
SONNEL)
NOTE: TO ACCESS THE INTERNAL PARTS
OF THE COOLER, REMOVE THE SCREWS
AND EVAPORATION PANELS, PLACE
THEM ON THE SIDES OF THE COOLER
(Pic. 2).
Handle the cooler with the utmost care, mov-
ing it horizontally.
-
(Pic. 3)
During installation, the electrical connection,
water connection, use and maintenance of
the cooler, comply with all local regulations
and standards in force.
3.2.1. The cooler must be installed on a sta-
ble and level structure, so as to prevent any
