DataCard Tru Photo Manual

DATACARD®TRU™PHOTO SOLUTIONS
The Datacard®Tru™Photo solution is completely software-driven and includes a digital camera, camera accessories and Tru™photo
software. Device drivers are integrated with the software, so the solution is easy to install and requires very little set-up time.
Tru photo solutions are engineered to integrate seamlessly with the entire family of Datacard photo ID software solutions.
• One-click capture. Operators click once in the
image field and the image is captured, cropped
and imported in less than seven seconds.
• Auto capture. Operators do not need to
preview the image, pan or tilt the camera
during capture.
• Auto crop. Operators do not need to crop
images. Images are automatically cropped
based on settings defined during set-up, which
helps ensure consistent cropping.
• Live video. Preview images on a computer
monitor before capture.
• External high-powered flash. When you need
more distance between camera and subject.
• Photo enhancement screen. Shows up to 27
thumbnails, each with a unique combination of
brightness, saturation and contrast.
SELECT DATACARD®
TRU™PHOTO SOLUTIONS
FOR FAST,
EASY IMAGE CAPTURE
With an integrated image capture
solution, you can complete the
process with one click of the mouse.
Capture, cropping and importing
take seven seconds or less.

Datacard and Tru are registered trademarks,
trademarks or service marks of DataCard
Corporation in the United States and/or
other countries.
© 2004 DataCard Corporation. All rights
reserved.Specifications subject to change
without notice.
Printed in U.S.A.
DC4-7001
11111 Bren Road West
Minnetonka, MN 55343-9015
[phone]
[phone] FAX
www.datacard.com
TO CAPTURE AN IMAGE
DATACARD TRU PHOTO
One step to capture, crop and input
image to photo ID software
TWAIN/VFW
Multiple steps to capture, crop and input
image to photo ID software
*TWAIN and VFW are industry standards. The camera manufacturers
determine how much of the standard they use. Therefore the steps
to capture images are not the same from camera to camera.
1. Pan camera 2. Tilt camera
3. Zoom in 4. Re-center
5. Start crop 6. Center crop box
7. Crop image 8. Zoom out / reset
1. Click once in image field
Done