Datamax E Class E-4203 User manual

92-2330-01 Rev.A
Ê
Printer
Connections
Serial
Connection
Parallel
Connection
USB
Connection
ToHost-OR-
-OR-Power
Connection
Ë
Media Sensor
Adjustment
(perform only if
equipped with the
optional AMS
feature)
WhileensuringtheReference
Lettermatches,position thetop
andbottomhalvesoftheMedia
Sensoroverthe gap,notch,
ormarkinthe media.
Ì
Media Loading
E-4203 / E-4204 / E-4304
Quick Start Guide
DatamaxInternational
Herbert House
12 Elizabeth Way, Pinnacles
Harlow, Essex CM19 5FE UK
Phone: [phone]
Fax: [phone]
Asia-Pacific
19 Loyang Way
#01-01 CILC Building
Singapore 508724
Phone: [phone]
Fax: [phone]
Corporate Headquarters
4501 Parkway Commerce Blvd.
Orlando, Fl 32808
Phone: [phone]
Fax: [phone]
For the latest in products, news,
and support visit our web page at
www.datamaxcorp.com

Í
Ribbon Loading
(perform only if
equipped with the
optional
Thermal Transfer
feature)
a)
Ensure that the Media Type
Switch is in the Transfer
position:
MediaType SwitchDirect
Transfer
b) Remove and load the Hubs:
Ribbon
EmptyCore
Slide aRibbon ontoaHub and
an EmptyCoreontoaHub
Pushinand lift
toremovethe Hubs
c)
Replace the Hubs so
that
the ribbon flows as shown
below:
þNote:Ensure the inked side of
the ribbon faces the
media andNOT the
printhead.
d) Route the ribbon through the printer, as shown below:
Wrap the end ofthe ribbon
around the EmptyCore
and secureitinplace
PRINTER SETUP MODE DEFAULT VALUES TABLE*
#
Menu Item Default
Value #Menu Item Default Value
1
2
3
4
5
6
7
8
9
10
MEDIA TYPE
SENSOR TYPE
PRESENT SENSOR
CUTTER EQUIPPED
SOP ADJUST
PRESENT ADJUST
BAUD RATE
DATA, PARITY
CONTROL CODES
CONT FORM LENGTH
DIRECT
EDGE
NO
NO
128
128
9600
8, N
STANDARD
100
11
12
13
14
15
16
17
18
19
20
21
OOS MAXVOLT
TOF GAIN
TOF DELTA
TOF LOW
LABEL WIDTH
SCALABLE FONT
INTERNAL MODULE
LABEL ALIGNMENT
ALIGN LENGTH
STOP LOCATION
INPUT MODE
2
10
10
0
410
64
128
NO
100
HOST
DPL
Î
Printer Front
Panel
’
Additional
Information
This table contains a list of the
printer’s menu items and the
associated default values.
These values can be changed
in the Printer Setup Mode.
*Certain item values can also be controlled via software.
‘
Test Label
Printing
With the printer ‘On’ and loaded with 4 inch wide media (and
ribbon, if needed):
Press the + buttons simultaneously; this will print
the Database Configuration Label.
ŸFor unpacking/repackaging information see the Operator’s Manual.
ŸFollow and perform the suggested maintenance as detailed in the Operator’s Manual.
ŸFor detailed information on the topics referred to in this guide consult the Operator’s
Manual; for detailed information on custom programming see the E-Class Programmer’s
Manual included on the Accessories CD-ROM.
Contacting Datamax…
Corporate Headquarters [phone]
Technical Support [phone]