Datapath VisionSC-DP2 User manual

Copyright Statement
© Datapath Ltd., England, 2019
Datapath Limited claims copyright on this
documentation. No part of this documentation may be
reproduced, released, disclosed, stored in any electronic
format, or used in whole or in part for any purpose other
than stated herein without the express permission of
Datapath Limited.
Whilst every eort is made to ensure that the
information contained in this documentation is correct,
Datapath Limited make no representations or warranties
with respect to the contents thereof, and do not accept
liability for any errors or omissions.
Datapath reserves the right to change specication
without prior notice and cannot assume responsibility for
the use made of the information supplied.
Datapath Limited acknowledges all registered
trademarks used within this documentation.
Audio and Video Capture Card
VisionSC-DP2
UK Headquarters
Datapath Ltd.,
Bemrose House, Bemrose Park,
Wayzgoose Drive,
Derby,
DE21 6XQ,
United Kingdom
Tel: [phone]
Fax: [phone]
US Oce
Datapath North America
2490 General Armistead Avenue
Suite 102
Norristown, PA 19403
USA
Tel: [phone]
Email: [email protected]
Web: www.datapath.co.uk
Product VisionSC-DP2 Quick Start Guide
Classication Released

Your packing box should contain the following items:
The VisionSC-DP2 - Dual DisplayPort capture card.
(For latest drivers go to www.datapath.co.uk).
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
PACKING LIST HARDWARE INSTALLATION SOFTWARE INSTALLATION
You are likely to need a at blade and/or a cross head
screwdriver for the installation of the VisionSC-DP2 card; it
would be useful to have these to hand before you begin.
Power down the PC (including peripherals), switch o at
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate reconnection
Remove the PC cover.
Locate a vacant PCIe slot (x4 or higher) on the motherboard
and remove the backing plate (retain all screws) .
If in doubt consult your motherboard documentation to
correctly identify a PCIe (PCI-express) slot.
Remove theVisionSC-DP2 card from its packaging and
secure it rmly into the empty PCIe slot.
Screw the VisionSC-DP2 bracket to the back panel of the PC
and replace the cover. Connect the cable(s) (not supplied)
distributing the signals to the connectors on the
VisionSC-DP2 card.
Reconnect all cables to the PC.
Download the the required driver install.exe from the
Support pages on the Datapath website and follow the
Installation Wizard instructions as prompted.
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
www.datapath.co.uk
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.
FLY-VSC-EN3-V1.0