Datapath The VisionHD4 User manual

Copyright Statement
© Datapath Ltd., England, 2014
Datapath Limited claims copyright on this
documentation. No part of this documentation may be
reproduced, released, disclosed, stored in any electronic
format, or used in whole or in part for any purpose other
than stated herein without the express permission of
Datapath Limited.
Whilst every eort is made to ensure that the
information contained in this documentation is correct,
Datapath Limited make no representations or warranties
with respect to the contents thereof, and do not accept
liability for any errors or omissions.
Datapath reserves the right to change specication
without prior notice and cannot assume responsibility for
the use made of the information supplied.
Datapath Limited acknowledges all registered
trademarks used within this documentation
Quad Channel Capture Card
VisionHD4
UK Headquarters
Datapath Ltd.,
Bemrose House, Bemrose Park,
Wayzgoose Drive,
Derby,
DE21 6XQ,
United Kingdom
Tel: [phone]
Fax: [phone]
Email: [email protected]
Web: www.datapath.co.uk

Your packing box should contain the following items:
The VisionHD4 capture card.
2 x DVI Splitter cables.
Installation CD-ROM.
(For latest drivers go to www.datapath.co.uk).
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
You are likely to need a at blade and/or a cross head
screwdriver for the installation of the VisionHD4 card; it
would be useful to have these to hand before you begin.
Power down the PC (including peripherals), switch o at
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate reconnection
Remove the PC cover.
Locate a vacant PCIe slot (x4 or higher) on the motherboard
and remove the backing plate (retain all screws).
If in doubt consult your motherboard documentation to
correctly identify a PCIe (PCI-express) slot. If the card is
forced into a 32 or 64 bit PCI or PCI-X slot it will be
irreparably damaged when the system is powered up and
the warranty will be void.
Remove theVisionHD4 card from its packaging and secure
it rmly into the empty PCIe slot.
Screw the VisionHD4 bracket to the back panel of the PC
and replace the cover.
Connect the cable(s) distributing the RGB or DVI signals to
the connectors on the VisionHD4 card. Reconnect all cables
to the PC.
Insert the Datapath CD into your CD drive, the CD will
autorun and display the following dialogue. If the CD
drive fails to autorun browse the CD and locate and
double click the setup.exe le.
Click on Install Drivers… and follow the Installation
Wizard instructions as prompted.
PACKING LIST HARDWARE INSTALLATION SOFTWARE INSTALLATION
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
( www.datapath.co.uk )
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.