Datapath VisionSD4+1S User manual

Copyright Statement
© Datapath Ltd., England, 2014
Datapath Limited claims copyright on this
documentation. No part of this documentation may be
reproduced, released, disclosed, stored in any electronic
format, or used in whole or in part for any purpose other
than stated herein without the express permission of
Datapath Limited.
Whilst every eort is made to ensure that the
information contained in this documentation is correct,
Datapath Limited make no representations or warranties
with respect to the contents thereof, and do not accept
liability for any errors or omissions.
Datapath reserves the right to change specication
without prior notice and cannot assume responsibility for
the use made of the information supplied.
Datapath Limited acknowledges all registered
trademarks used within this documentation.
Four Channel Video and One Channel RGB/
DVI/ HD Capture Card
VisionSD4+1S
UK Headquarters
Datapath Ltd.,
Bemrose House, Bemrose Park,
Wayzgoose Drive,
Derby,
DE21 6XQ,
United Kingdom
Tel: [phone]
Fax: [phone]
US Oce
Datapath North America
2490 General Armistead Avenue
Suite 102
Norristown, PA 19403
USA
Tel: [phone]
Email: [email protected]
Web: www.datapath.co.uk

Your packing box should contain the following items:
The VisionSD4+1S video capture card.
1 x SD4-Cable.
1 x DVI-VGA, 1 x DVI/Component and 1 x DVI/HDMI
Adapters.
Installation CD-ROM.
(For latest drivers go to www.datapath.co.uk).
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
You are likely to need a at blade and a Phillips head
screwdriver for the installation of the capture card;
installing the card is a simple process, follow the steps
below to be up and running in a few minutes.
Power down the PC (including peripherals), switch o at
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate reconnection.
Remove the PC cover.
Locate a vacant PCI Express (x4 or above) slot on the
motherboard and remove the backing plate (retain all
screws).
If in doubt consult your motherboard documentation to
correctly identify a PCI Express) slot. If the card is forced
into a 32 or 64 bit PCI or PCI-X slot it will be irreparably
damaged when the system is powered up and the warranty
will be void.
Remove the card from its packaging and secure it rmly
into the empty PCIe slot.
Extreme care should be taken when securing the card into
the slot as some motherboards may have components that
impede the siting of the card.
Screw the card bracket to the back panel of the PC and
replace the cover. Re-connect all cables to the PC.
Connect the input cables. Power up the PC and commence
the software installation.
Reconnect all cables to the PC then connect the cable
distributing the RGB/ DVI/video signals to the connectors
on the VisionSD4+1S card located on the back panel.
Insert the Datapath CD into your CD drive, the CD will
autorun and display the following dialogue. If the CD
drive fails to autorun browse the CD and locate and
double click the setup.exe le.
Click on Install Software… and follow the installation
Wizard instructions as prompted.
PACKING LIST HARDWARE INSTALLATION SOFTWARE INSTALLATION
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
(www.datapath.co.uk
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.