Datapath IQS4 User manual

Engineering the world’s best visual solutions
6U Rack Shelf
Assembly
Instructions
For products:
Aligo
IQS4

x1
Pre-Assembled 6U Rack
x40
M4 x 35mm Pozi Head
Countersunk Screws
x10
Device Mounting Plate
Assembly (Long screws
and circlips pre-tted)
x2
PSU Modules
x8
M4 x 8mm Pan
Head Pozi Screw
x8
M4 Nut
x10
Device Power Lead
(with molex 2-way
and 760k connectors)
x2
2-Way Screw
Terminal Plug Zero
volt connector for
power supply status
monitoring by external controller
x12
M6 Screws
x12
M6 Cage Nut
x2
Mains Power Lead
(Country Dependant)
x2
Rack Rear
Support Bar
TOOLS NEEDED TO ASSEMBLE RACK:
1 x Cross Head Screwdriver
1 x Pozi Head Screwdriver
1 x Flat Head Screwdriver (Note: Only needed if using the volt free contact connector)
Contents
2

Assembly and Fitting Instructions
3
Remove the front
cover by pushing the
latch (to the right).
This will release the
whole panel.
1
2
Unpack the rack and the accessories, checking the contents.
Push M6 caged nuts into the 19”cabinet front and rear.
3

A
A
A
4
Fit the rack into
the 19” cabinet,
secure using
M6 screws.
5
It’s recommended to
provide extra stability
by tting the rear
supports to the rack
on each side using
M4 screws.
A
6
Secure the rear
supports to the
rear of the 19”
cabinet using
M6 screws.
4

7
8
Insert the PSU
modules until they
click into place.
If the automatic power supply
fail warning is desired: wire
the normally open contacts to
the cabinet alarm system. ‘12V
status’contacts open when all
power is lost. ‘1+1 PSU status’
contacts open when either
PSU module fails.
5

9
10
Connect the individual unit
power supply connectors.
If not connected, connect the
individual unit power supply
connectors to the PCB as shown
and to the individual unit.
Fit the Aligo/IQS4
units to the backing
plates using 35mm
M4 screws.
11
Slide the units into the
rack, making sure the
screw is lined up to the
hole and screw in place
to securely attach on. To
ensure proper airow
through the system,
please ensure all units
are mounted in the
orientation as illustrated.
The Datapath logo should
be towards the top.
6

12
14
15
13
Connect both rack power supplies to the mains using the supplied mains leads.
Check the two LED indicators on the front are working. Both lights should appear on. Note: under normal circumstances
both the ‘power’ and ‘backup power’ lights should be on, indicating that the system is in dual redundant mode and backup
power is available. If only one working power supply is detected, then only the primary power LED will be lit up.
On the rear of the unit, check that both the PSUs are working. Both LEDs should appear on.
Switch the power on.
16
Place the rack
front cover
back on.
7

QSG-RMK-EN2-V1
Datapath UK and
Corporate Headquarters
Bemrose House, Bemrose Park,
Wayzgoose Drive, Derby,
DE21 6XQ, United Kingdom
[phone]
[email protected].uk
www.datapath.co.uk
Datapath North America
2490 General Armistead Ave,
Suite 102, Norristown,
PA 19403,
USA
[phone]
[email protected].uk