DATATRAC 400H Manual

DATATRAC 400H Setup Instructions To Clear GPS NVM
Contents
Set up of the Data track................................................................................................................................ 1
Transmitter SETUP ........................................................................................................................................ 1
Receiver SETUP ............................................................................................................................................. 2
Label setup.................................................................................................................................................... 3
Bus setup ...................................................................................................................................................... 4
End of Procedure .......................................................................................................................................... 4
Set up of the Data track
Transmitter SETUP
1. Switch On/Off: ON
a. Press “XMT” Key
b. Press “ENTER” Key
i. “TRANSMITTER SETUP” page displays
2. On the “TRANSMITTER SETUP” page
a. On/Off: ON
b. Bus speed : 100
c. Function: KEY
d. Equipment ID: 000
e. Data Format: HEX32
f. Display Lines: 03
Note: Use “^””v” to move to next/previous line
Use “>” To step through options

DATATRAC 400H Setup Instructions To Clear GPS NVM
Receiver SETUP
1. Press “RCV” Key
a. “RECEIVER SETUP” page displays
2. On the “RECEIVER SETUP” page
a. Channel: 1
b. On/Off: ON
c. Bus speed : 100
d. Select LBLS: EDIT
e. Equip ID: 000
f. Data Format: BIN19L
g. Interval: INST
h. RCV Download: NONE
i. Display Lines: 03
j. Bus Monitor: 2
Note: Use “^””v” to move to next/previous line
Use “>” To step through options
Use Keypad to enter alphanumeric entries

DATATRAC 400H Setup Instructions To Clear GPS NVM
Label setup
1. Navigate to “Select Lbls: EDIT”
a. Press “ENTER” Key
i. “SELECT LABEL SETUP” page displays
2. On the “SELECT LABEL SETUP” page
a. Enter Label : 150-D
b. Enter Label : 260-D
Note: Entry of D displays “X” (Example: 150-X)
Use “>” To step through options
Use “^””v” to move to next/previous line
Use Keypad to enter alphanumeric entries

DATATRAC 400H Setup Instructions To Clear GPS NVM
Bus setup
1. Press “ENTER” Key
a. SELECT LABEL PAGE #2 page displays
2. On the “SELECT LABEL PAGE #2” page
a. Select “XMT” key
b. Enter values as displayed in the following table:
LBL
SDI
32 HEX DATA -1
SSM
Par
Msec
377
00
00
00
2C
FF
00
1
0040
047
00
80
04
80
E4
00
1
0040
Note: Page does not contain a title
Use “>” To step through options
Use “^””v” to move to next/previous line
Use Keypad to enter alphanumeric entries
End of Procedure
1. Please refer to Service Information Letter 523-0826445 for complete NVM reset procedure.