MICROPHONE INPUTS
Connectors: Female XLR Pin 2 hot
Type: Electronically balanced/unbalanced
Impedance: 1.70 k½
Optimum Microphone Impedance: 150 - 200 ½
Maximum Input Level: > +13 dBu, or +33 dBu with 20 dB pad
engaged
CMRR: > 115 dB at 60 Hz, > 110 dB at 1 kHz, >
75dB at 10 kHz
LINE INPUTS
Connectors: Female XLR Pin 2 hot and TRS 1/4Ó
Type: Electronically balanced/unbalanced
Impedance: 20.1 k½ nominal, or 470 k½ with rear-panel
INST switch engaged
Maximum Input Level: > +30 dBu, or +22 dBu with rear-panel
INST switch engaged
OUTPUTS
Connectors: Male XLR Pin 2 hot and TRS 1/4Ó
Type: Servo-balanced/unbalanced, RF filtered
Impedance: Balanced 120½, unbalanced 60½
Maximum Output Level: +21.5 dBu, balanced or unbalanced
INSERT
Connectors: TRS 1/4Ó
Type: Impedance balanced/unbalanced (SEND),
electronically balanced/unbalanced
(RETURN)
Impedance: 100½ bal./50½ unbal. (SEND), 20k½
(RETURN)
Nominal Send Level: +4 dBu
Nominal Return Level: +4 dBu
EQUALIZER
LOW Frequency: 80 Hz, shelving filter
HIGH Frequency: 12 kHz, shelving filter
MID Frequency: Sweepable from 100 Hz to 8 kHz,
bandwidth 1.5 octaves (WIDE) or 0.5
octaves (NARROW)
Gain (all bands): Sweepable from -15 to +15 dB.
COMPRESSOR
Treshold range: -40dBu to +20dBu
Ratio: 1:1 to °:1
Threshold Characteristic: Selectable OverEasy¨ or hard knee curves
Attack/Release Characteristic: AutoDynamicª
Attack/Release Modes: Selectable Manual or Auto
Manual Attack Time: Scalable program-dependent. Typically
3dB/ms to .04dB/sec
Manual Release Time: Scalable program-dependent. Typically
250dB/sec to 5dB/sec
Auto Attack Time: Program-dependent. Typically 15ms for
10dB, 5ms for 20dB, and 3ms for 30dB
Auto Release Time: Program-dependent. Typically 125dB/sec
Output Gain: -15 to +15dB
PeakPlus LIMITER
Type: Two-stage proprietary
Threshold Range: +4 dBu to >+ 22 dBu (off)
Ratio: °:1
Stage 1 Attack and Release Time: Zero
Stage 2 Attack Time: Program-dependent, typically < 5ms
Stage 2 Release Time: Program-dependent, typically 22dB/sec
SYSTEM PERFORMANCE
DRIVE Control Range: +10 dB to +60 dB
LEVEL Control Range: -15 dB to +15 dB
0.5 dB Bandwidth: 15 Hz to > 90 kHz +0/-0.5 dB
Frequency Response: <10 Hz to >200 kHz +0/-3.0 dB
EIN: Typically -126 dBu, 150½ source
impedance, unweighted, 20 Hz to 20 kHz
measurement bandwidth
THD + Noise: 0.04% typical at +0 dBu out, 1kHz, 33 dB
gain
3.5% typical at +21 dBu out, 1kHz, 35 dB
gain
Deviation From Linear Phase: < 20 degrees, 20 Hz to 20 kHz.
Interchannel Crosstalk: Typically -98 dB, 20 Hz to 20 kHz.
POWER SUPPLY
Operating Voltage: 100V, 120V, or 220-240VAC 50/60 Hz.
Power Consumption: 30 Watts maximum.
Fuse: 100V: 315mA 250V Slow Blow 5mm X
20mm
120V: 315mA 250V Slow Blow 5mm X
20mm
220-240V: T160 mA 250V 5mm X 20mm
Mains Connection: IEC 320 Receptacle
PHYSICAL
Dimensions: 3.5" H X 19" W X 8" D
Weight: 12 lbs (5.5 kg)
Shipping Weight: 13 lbs (5.9 kg)
Note: 0 dBu = 0.775V RMS.