Defibtech Lifeline/ReviveR DDU-100 User manual

DAC-A581-EN-DJ
Defibtech Automated External Defibrillator
• Lifeline/ReviveR DDU-100
• Lifeline/ReviveR AUTO DDU-120
Operating Guide
For concise guidance on
set-up, use, maintenance
and technical specifications
check pads
do not touch patient
analyzing
check pads
do not touch patient
analyzing
ELECTRONIC
DISTRIBUTION

10 11
DAC-A581-EN-DJ DAC-A581-EN-DJ
For more detailed information, refer to the User Manual (at www.defibtech.com).
USING THE AED
1
2
TURN
AED ON
PREPARE
THE PATIENT
Press ON/OFF button to turn AED on.
Follow the voice prompt instructions.
(NOTE: To power off the AED at any time, press and hold
the ON/OFF button for approximately two seconds.)
Remove clothing from patient’s chest.
If necessary, dry chest and remove excess chest hair.
3
4
PREPARE PADS
PLACE PADS
Peel adhesive pads
from blue liner.
Tear open
pads package.
Apply pads to patient’s bare chest.
For more information, refer to page 14.
ADULT
PATIENT
CHILD/INFANT
PATIENT
OR
If the patient is unconscious or unresponsive, and is
not breathing or not breathing normally, ensure emergency
medical assistance has been called and start using the AED.

12 13
DAC-A581-EN-DJ DAC-A581-EN-DJ
For more detailed information, refer to the User Manual (at www.defibtech.com).
USING THE AED (continued)
5
6
STAND CLEAR
IF INSTRUCTED,
PRESS SHOCK
BUTTON
When instructed, do not touch the patient.
7
8
PERFORM CPR
CONTINUE
TO FOLLOW
INSTRUCTIONS
Follow instructions to perform CPR, if needed.
Continue to follow the voice prompt instructions.
If instructed, press “SHOCK” button.
IMPORTANT: The semi-automatic DDU-100 AED
will deliver the shock after the SHOCK button has
been pressed; the fully-automatic DDU-120 AED
will shock the patient automatically without any user
intervention. Do not touch the patient while the
SHOCK Required (“auto”) indicator is flashing.
auto