
10 Mountain View Drive | Shelton, CT 06484 | P: 800-521-3175 | www.electri-cable.com
9065-0366 REV D © ECA– January 2019—Product specifications subject to change without notice
STO-WAY (RECESSED) WOOD INSTALLATION
Installation instructions:
1- Remove the finish cover plate from the Power unit(s) (A). Save the screws (C) for use later.
2- Determine the power units mounting location and prepare the surface (FIG.1).
3- Loosen the 4 Locking nuts on the mounting brackets (FIG.2). Expose adhesive back and press in place to seat
tape.
4- Align the face of the unit with the inner surface of the Locker. Snug the Mounting bracket against the back panel
and insert the 4 wood screws (B). *Do not pierce finished surfaces. Confirm inner surface alignment and tighten
the Locking nuts. Take care not to over tighten.
5- Attach the finish cover plate via the two center holes on the power unit using the two screws(C) removed in step
1 (FIG.2).
6- Repeat steps 1-5 for each Power unit in the circuit.
7- Beginning with the last Sto-Way in the circuit; attach the Safety cover (D) to the unused connector. (FIG.4).
Connect the whip to the next Power unit (FIG.3). Repeat this for all units in the system.
8- At the first Sto-Way in the circuit attach the power infeed (sold separately). Energize the circuit (FIG.3).
(C) 8 x 3/8” Flat Screws
QTY. 2 (installed)
(B) Wood Screw
#8 x ½” Qty. 4
Note: Unit is not for permanent installation as part of the building structure and not for mounting in a permanently installed
furnishing such as a countertop. Unit is to be mounted about the furnishing surface and oriented in such a way that spilled liquid
on the furnishing surface cannot enter any part of the unit. *Recommended mounting for System 42 and cord to wood of .625”
to 1.00” thick with supplied hardware. ** Use for System 42 and corded versions. Do not connect more than 12 outlets on one
circuit. Caution: Disconnect electrical load before servicing the unit.