Dell SFF User manual

Dell SFF Wall Mount
Patent(s) Pending
104-5490 Kit P/N:
Installation Instructions

Determine Location: Select an appropriate location on the wall. Consider cable
routing and length.
Step 1
Wall Mount Hardware Package:
(4) Pan Head Screw
(4) Anchors
Kit Contents:
(1) Main Bracket
Monitor Hardware Package:
(8) Nylon Spacers
(5) M4 x 10mm Flat Head Screws
(5) M4 x 12mm Flat Head Screws
(5) M4 x 20mm Flat Head Screws
PC Wall Mount Installation Instructions
Step 2 Mark Hole Positions: Hold the base in position and mark 4 hole positions with a
pencil.
Install Drywall Anchor:
Install one drywall anchor at each hole mark. Using a #2
Philips head screwdriver press the anchor into the drywall while turning clockwise
until it is seated flush with the wall.
Step 3a
Install 4 Screws:
Leave 1/4" of each screw protruding out of the wall. Step 3b
Kit Contents
Page 2

Main Bracket
(4) Metric
Screws
(See Table below)
Spacers
(See Table below)
Recess
VESA Hole Pattern
Monitor
Step 4 Monitor Attachment:
Turn the monitor face down on a large flat surface. Locate the
four VESA mounting holes on the rear of the monitor.
a. Determine if spacers are required
: Some monitors have a "recess" on the rear
surface. Spacers are provided to fill this gap. See Table A for spacer length options.
b. Determine Screw Length
: Only use the metric M4 screws provided. Screw length is
determined by the spacers used (see Table A).
Installation Instructions
Page 3

.37
.19
Main Bracket
Dell SFF Computer
Step 6 Attach Mount Base:
Attach the base to the wall using the 4 srews that were installed
in 3b. Tighten securely.
Step 5 Computer Attachment:
Slide the computer into the Main Bracket.
.37
.19
Installation Instructions