Dell RETAIL-DELL-WALL-001 User manual

Dell Computer and Monitor
USFF Wall Mount
Installation Instructions
Kit P/N: RETAIL-DELL-WALL-001
Patent(s) Pending

Page 2
Kit Contents
Assembly Components:
(1) Main Bracket
(1) Monitor Bracket Assembly
Monitor Hardware Package:
(5) 6-32 Flat Head Screws
(5) 10-32 Flat Head Screws
(8) Nylon Spacers
(5) M4 x 10mm Pan Head Screws
(5) M4 x 14mm Pan Head Screws
(5) M4 x 20mm Pan Head Screws
(5) M4 x 25mm Pan Head Screws
Wall Mount Hardware Package:
(4) Pan Head Screw
(4) Anchors
PC Wall Mount Installation Instructions
Step 1. Determine Location: Select appropriate location on wall. Consider cable routing
and length.
Step 2. Mark Hole Positions: Hold base in position and mark 4 hole positions with pencil.
Step 3a. Install Drywall Anchor: Install one drywall anchor at each hole mark. Using a
#2 Phillips head screwdriver press the anchor into the drywall while turning
clockwise until it is seated ush with the wall.
Step 3b.Install 4 Screws: Leave 1/4" of each screw out of wall.
1/4"

Installation Instructions
Page 3
Step 4a. Monitor Attachment: For standard monitors with 100mm mounting patterns,
mount the pivot bracket as shown. Make sure the orientation matches below.
M4 Screws (4x)
M4 Screws (4x)
Pivot Assembly
Pivot Assembly
Bottom of Monitor
Bottom of Monitor
Outer four holes
= 100mm
Outer four holes
= 100mm
Step 4b.Alternate Monitor Attachment: For standard monitors with 75mm mounting
patterns or requiring space to clear rear of Monitor of a 100 mm mount the pivot
bracket as shown using alternate hardware. Make sure orientation matches
below.

Warranty Statement
Innovation First, Inc. warrants our products against defects in material and workmanship for a
period of one (1) year from the date of purchase. Innovation First, Inc. liability shall be limited to
repairing or replacing, at our option, any defective product.
752
Step 6. Computer Attachment: Slide computer into Main Bracket and install 6-32 Flat
Head Screws as shown.
Installation Instructions
Step 7. Attach Mount Base: Attach base to wall using the 4 screws that were installed in
3b. Tighten Securely.
Step 5. Assembly: Remove main Bracket if it is attached to the wall before continuing
with this step. The monitor can be mounted at different heights depending on
your application. Mount the monitor assembly through the Main Bracket using the
included screws.