dellonda DH47 User manual

Thank you for purchasing a Dellonda product. Manufactured to a high standard, this product will,
if used according to these instructions, and properly maintained, give you years of trouble free performance.
DH47, DH48 Issue:2 23/07/20
www.dellonda.co.uk

Please read these instructions carefully. Note the safe operational requirements, warnings & cautions. Use the product correctly and with care
for the purpose for which it is intended. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these
instructions safe for future use.
Refer to
instruction
manual
DH47:
prolonged use. Cushioned headrest and lumbar support. Adjustable 2D (two directional) arm rest, 360° swivel base and 95-135° reclining backrest
allow you to adjust chair to your comfort preference. Five point nylon base with Ø50mm nylon casters.
DH48:
prolonged use. Cushioned headrest and lumbar support. Adjustable 4D (four directional) arm rest, 360° swivel base, 95-155° reclining backrest
patches. Five point reinforced metal base with Ø75mm nylon castors.
• DO NOT
• DO NOT use on a high or unstable place.
•
•
• Prevent sharp objects from scratching the chair.
• Prevent over tilting the chair, it may fall over.
of the chair, with your
back to the backrest.
DO NOT sit at
the front edge of the
chair.
DO NOT stand
on the chair.
DO NOT use the chair
with more than one
person.
DO NOT push
the chair around
when there is a
person sitting in it.
DO NOT push
down on the
backrest when a
person is reclined.
DO NOT place all your
weight on the backrest
only.
DO NOT place
your hand or fingers
near the reclining
mechanism.
DH48DH47
Back rest
DH48 mechanism
DH47 mechanism Five star base
Recliner covers (2) Wheels
Gas strut
cover Gas strut

fig.1a fig.1b fig.2
fig.3
FIT BACK REST AND SEAT TOGETHER
•
the bolts can be inserted.
FIT BOLTS ON BACK REST AND SEAT
•
• Remove the bolts that are pre-mounted in the backrest.
•
screw in the two bolts on the left side. Now tighten the bolts on both sides.
•
the hole on the recliner cover. Fit the screw covers.
•
together. Ensure the bolts are screwed in tight.
• Insert the handles.
fig.4a fig.4b

INSTALL THE WHEELS,
INSTALL THE GAS STRUT,
INSTALL THE GAS STRUT COVER,
• Insert the top of the gas strut into the hole in the mechanism.
fig.5a fig.6a fig.7a
fig.7b
fig.8
fig.6b
fig.5b
Dellonda Limited
Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757575 suppo[email protected]o.uk www.dellonda.co.uk
notice.
12 months from purchase date, proof of which will be required.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.