8
5. Press the OK icon (B15) to conrm (or ESC (B14)
to exit without making any change). The lights go o.
The energy saving setting is now programmed.
Please note:
• In energy saving mode, a few seconds may elapse before
the rst coee is delivered as the appliance must heat up
again.
10. BEEP
This function enables or disables the beep. Proceed as follows:
1. With the machine o (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon (B9) until the indicators on the
touch screen (B) light up.
3. Press the icon to enable/disable the function:
• function enabled
• function disabled
4. Press the OK icon (B15) to conrm (or ESC (B14)
to exit without making any change). The lights go o.
The beep is now programmed.
11. DEFAULT VALUES RESET
This function resets all settings (temperature, auto-o, water hard-
ness, energy saving and all quantity settings are reset to the default
values).
1. With the machine o (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon (B9) until the indicators on the
touch screen (B) light up.
3. Press the icon (B12): the beans (B7) on the touch
screen will blink;
4. Press the OK icon (B15) to reset the default values (or
ESC (B14) to exit without making any change). The
lights go o.
The settings and quantities of the beverages have been reset to
the default values.
12. RINSING
Use this function to deliver hot water from the coee spouts
(A9) to clean and heat the appliance’s internal circuit.
Place a recipient under the coee and hot water spouts.
Important! Danger of scalding.
Do not leave the appliance unattended while hot water is being
delivered.
1) To activate the function, press OK(B15);
2) After a few seconds, hot water is delivered from the cof-
fee spouts, cleaning and heating the appliance’s internal
circuit.
3) To interrupt the function manually, press OK again.
Please note:
• If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
• AFTER cleaning, it is normal for the coee grounds con-
tainer (A11) to contain water.
13. MAKING COFFEE
13.1 Adjusting the coee mill
The coee mill is set by default to prepare coee correctly and
should not require regulating initially.
However, if after the rst few attempts it becomes apparent that
the coee is either too weak and not creamy enough, or emerg-
es too slowly (drop by drop), this can be corrected by adjusting
the grinding adjustment dial (A5) (g. 7).
7
Please note:
The grinding adjustment dial must be used only when the coee
mill is in operation.
If the coee is delivered too slowly or not
at all, turn one click clockwise towards 7.
For fuller bodied creamier coee, turn
one click anticlockwise towards 1 (do not
turn more than one click at a time other-
wise the coee could be delivered a drop
at a time).
The eect of the adjustment will be noticed only after making
a further 2 cups of coee, at least. If this adjustment does not
produce the desired result, turn the dial another click.
13.2 Tips for a hotter coee
To make a hotter coee, proceed as follows:
• perform a rinse cycle by pressing OK (B15);
• warm the cups with hot water using the hot water function
(see section“15. Delivering hot water”);
• increase the coee temperature (see section “18. Setting
water hardness”).
