CAUTION: Use ofcontrols or adjustmentsor performance ofprocedures other thanthose specified herein may result in
hazardous radiation exposure.
Please carefully studythis manual andalways keep itavailable. There are,however, some installation and operation precautions
which You should be aware of.
1.Read Instructions -All thesafety and operatinginstructions should beread before theproduct is operated.
2.Retain Instructions -The safety andoperating instructions shouldbe retained forfuture reference.
3.Heed Warnings - Allwarnings on theproduct and inthe operating instructionsshould be adheredto.
4.Follow Instructions -All operatingand use instructionsshould be followed.
5.Cleaning - Unplugthis product fromthe wall outletbefore cleaning. Donot use liquidcleaners or aerosol cleaners. Use a damp
cloth for cleaning.
6.Attachments - Donot use attachmentsnot recommended bythe product manufactureras they maycause hazards.
7.Water and Moisture - Donot use thisproduct near water- for example,near a bath tub, wash bowl, kitchen sink, or laundry tub; in a
wet basement; ornear a swimmingpool; and thelike.
8.Accessories - Donot place thisproduct on anunstable cart, stand,tripod, bracket, or table. The product may fall, causing serious
injury to achild or adult,and serious damageto the product.Use only with a cart, stand, tripod, bracket, or table recommended by the
manufacturer, orsold with theproduct. Anymounting of theproduct should follow the manufacturer’s instructions, and should use a
mounting accessory recommended by the manufacturer.
9.Aproduct and cartcombination should bemoved with care.Quick stops, excessiveforce, and unevensurfaces may cause the
product and cartcombination to overturn.
1 0. Ventilation - Slots and openings in the cabinet are provided for ventilation and to ensurereliable operation ofthe product andto
protect it fromoverheating, and theseopenings must notbe blocked orcovered. The openingsshould never be blocked by placing the
product on abed, sofa, rug, or other similar surface. This productshould not be placed in a built-in installation such as a bookcase or
rack unless properventilation is provided or the m a n u f a c t u r e r’s instructions have been adhered to.
11.Power Sources- This product should be operated only from the type of power source indicated on the marking label. If you are not
sure of thetype of power supply to your home, consult your product dealer or local power company. For productsintended to operate
from battery power, or other sources, refer to the operating instructions.
Safety Information
12.Grounding or Polarization This product may be equipped with a
polarized alternating-current line plug (a plug having one blade wider than
the other). Thisplug will fit into the power outlet only one way, This is a
safety feature. Ifyou are unable to insert the plug fully into the outlet, try
reversing the plug.If the plug should still fail to fit, contact your electrician to
replace your obsoleteoutlet. Do not defeat the safety purpose of the
polarized plug.
Alternate Warnings This product isequipped with a three-wire grounding-
type plug, aplug having a third (grounding) pin. This plug willonly fit into a
grounding-type power outlet.This is a safety feature, If you are unable to
insert the pluginto the outlet, contact your electrician to replace your
obsolete outlet. Donot defeat the safety purpose of the grounding-type plug.
13.Power-Cord Protection Power-supply cords should be routed so that
they are notlikely to be walked on or pinched by items placed upon or
against them, payingparticular attention to cords at plugs, convenience
receptacles, and thepoint where they exit from the product.
14.Protective AttachmentPlug The product is equipped with an attachment
plug having overloadprotection. This is a safety feature. See instruction
Manual for replacementor resetting of protective device. If replacement of
the plug isrequired, be sure the service technician has used a replacement
plug specified bythe manufacturer that has the same overload protection as
the original plug.
15.Outdoor AntennaGrounding - If an outside antenna or cable system is connected to the product, be sure the antenna or cable
system is groundedso as to provide some protection against voltage surges and built-up staticcharges. Article 810 of the National
Electrical Code,ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding
of the lead-inwire to an antenna discharge unit, size or grounding conductors, location ofantenna-discharge unit, connection to
grounding electrodes, andrequirements for the grounding electrode.
16.Lightning - Foradded protection for this product during a lightning storm, or when itis left unattended and unused for long periods
of time, unplugit from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to
lightning and powerlinesurges.
17.Power Lines -An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or
power circuits, orwhere it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should
be taken tokeep from touching such power lines or circuits as contact with them might be fatal.
1 8.Overloading -Do not overload wall outlets, extension cords, or integral convenience receptacles asthis can result in a risk of fire
or electric shock.
19.Object and LiquidEntry - Never push objects of any kind into this product through openings as they may touch dangerous voltage
points or short-outparts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
20.Servicing - Donot attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or
other hazards. Referall servicing to qualified service personnel.
2 1.Damage RequiringService - Unplug this product from the wall outlet and refer servicingto qualified service personnel under the
following conditions:
a. When thepower-supply cord or plug is damaged.
b. If liquidhas been spilled, or objects have fallen into the product.
c. If theproduct has been exposed to rain or water.
d. If theproduct does not operate normally by following the operating instructions. Adjust only those controls that are covered by the
operating instructions asan improper adjustment of other controls may result in damage and willoften require extensive work by a
qualified technician torestore the product to its normal operation.
e. If theproduct has been dropped or damaged in any way, and
f. When theproduct exhibits a distinct change in performance - this indicates a need for service.
22.Replacement Parts -When replacement parts are required, be sure the service technician has usedreplacement parts specified
by the manufactureror have the same charateristics as the original part. Unauthorized substitutions may result in fire, electric shock,
or other hazards.
23.Safety Check -Upon completion of any service or repairs to this product, ask the service technician to perform saftey checks to
determine that theproduct is in proper operating condition.
24.Wall or Ceiling Mounting -The product should be mounted to a wall or ceiling only as recommended by the manufacturer.
25. Heat -The product should be situated away from heat sources such as radiators, heat registers, stoves or other products
(including amplifiers) thatproduce heat. 2
FIGURE A
EXAMPLE OF ANTENNAGROUNDING
AS PER NATIONALELECTRICALCODE
ANTENNA
LEAD
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUD CLAMP
POWER SERVICE
GROUNDING ELECTRODE
SUSTEM
(NEC ART 250, PARTH)
NEC-NA TIONALELECTRICALCODE
S2898A
ELECTRIC
SERVICE
EQUIPMENT
GROUND
CLAMP
33
Specifications
DVD Player
TV System NTSC/PAL
Compatible Discs DVD+R, DVD, CD, Mp3,
DVD+RW,CD-R, CD-RW
Recordable discs format DVD+RW, DVR+R
Resolution Ratio Greater Than 500 lines
Video S/N Ratio 65dB
Frequency Response fs (96KHz/24bit)
4Hz - 44KHz:+/-2dB
Audio S/N Ratio 95dB
Degree of Distortion <0.01%
D/A Converter 192KHz/24bit
Video Out 1Vp-p
S-Video Out Y: 1Vp-p(75 )
C: 0.3Vp-p(75 );
Audio Out 2.0V
5.1 Channel,2Channel mixed
Digital Audio Output Optical, Coaxial
Connections YUV, SCART, CVBS
S-Video
Remote Control
Transmitter Infrared Ray
Signal Range Approximately 15'
Power Source 2 AAA Batteries
General
Power Supply AC 230V 50Hz
Consumed Power 30W
Standby Power <3W
Size (WxHxD)
Because its products are subject to continuous
improvement, We reserves the right to modify
product design and/or specifications without
notice and without incurring any obligations.
""
