Dermalogic MSI-TWAPP-05 User manual

Rotate to remove the UV light installed in
the towel warmer and replace it when
needed.
1. Take out the drainage tray to drain the
wastewater regularly as shown (Fig. 1).
2. Use a wet cloth to clean the surface of the
towel warmer.
-4-
About UV Light
Daily Maintenance
Troubleshooting Checklists
Issue(s)
Possible Cause(s)
Solution(s)
The appliance
could not be
turned on.
1. Connection of
machine and
power cable are
loosened.
2. The fuse at the
back has blown
1. Check the connection of
the power cable and the
towel warmer. Reconnect
them to see if the problem
could be solved.
2. Replace the fuse.
The door could
not be fully
closed
1. The screw on the
door hinge is
loosened
1. Adjust the door position
and retighten the screws
UV TOWEL WARMER MANUAL
ITEM: MSI-TWAPP-05
Thank you for purchasing our Dermalogic Towel Warmer. To use this
product safely and correctly, please read this manual carefully and
abide by all directions and notes.

Towel Warmer x 1
Shelf x 1
Power Cord x 1
-2-
-3-
Safety Instructions
1. Make sure the appliance is plugged into a sufficient outlet.
2. Children are not allowed to operate this appliance for safety
concerns.
3. Place the appliance on a flat, level, and solid surface.
4. If you want to sterilize wet towels, make sure that the wet towel is
not dripping water. If it is dripping water, wring it first before putting
it into the appliance.
5. Remember to regularly disconnect the power and clean the stagnant
water inside the towel warmer
6. Take out the sterilized items from the appliance with tweezers, avoid
using bare hands.
7. Never use any corrosive detergents to clean the appliance or its
shelves.
8. DO NOT open or close the door with excessive force.
9. Keep the appliance away from explosive and flammable materials.
Ensure that the distance between the appliance and the surrounding
material is at least 30 cm.
10. For protecting your eyes, do NOT stare at the UV light tube directly
when it is operational.
11. Always ensure the door of the appliance is closed when it’s working.
Specifications
Overall Dimensions
(LxWxH)
8-7/16” x 10-3/8” x 11-11/16”
(21.4 x 26.4 x 29.7 cm)
Voltage
110V, 60Hz
Power
200W
UV Light Power
3W
Heating Temperature Range
158F to 176F (70C to 80C)
Type of UV Light
E17
Tank Capacity
5L
Net Weight
7.7 Lbs (3.5 kg)
Package Contents
Operating Instructions
1. Confirm that the power switch is “OFF” and then firmly insert the
plug to the socket.
2. Moisten towels before placing them in the towel warmer to be
heated. Towels should be moist but not dripping wet.
3. Take the rack out of the warmer and fold or roll the moist towels
neatly and then place them on the rack. Do not place too many
towels; to prevent them from making direct contact with the
warmer.
4. Close the door firmly and press the power button . The red
indicator light will come on and the unit will begin to heat.
5. Press the UV button to start UV sterilizing. The red indicator light
will come on and the UV light in the warmer will be on.
6. The heating and sterilizing function can work individually or
simultaneously. Press both buttons to work simultaneously.
7. This unit has an auto-shutdown feature. When the temperature
reaches its maximum, the power will automatically turn off. Once
the temperature lowers again, the machine will power back on.