Designs for Vision NanoCam 4K User manual

NanoCam 4K/NanoCam Quick Start
Part A: Initial Setup
You’re NanoCam 4K/Go comes with the following: Footpedal, Footpedal USB Receiver, USB Cable, USB
Extension Cable, Blue Cap Hex Driver
-The DBR software is loaded onto the Designs for Vision Chrome Cap USB Stick supplied with
your camera.
-If you already have the DBR software, you must make sure you have version 1.1.3 loaded.
-
Part B: Setting up the Footpedal
The footpedal is controlled using a wireless Bluetooth module. You must plug in the module to the
nearest USB port.
To operate the foot pedal, insert Bluetooth Receiver into the USB port on your device, as shown below:
You can test to make sure the footpedal is working properly before use. The footpedal is pre-set to work
with the DBR software. Plug in your camera to the USB port or adapter depending on your setup. The
footpedal will not work without the camera plugged in.
-Pressing the left side of the pedal will allow you to record video. Press once to start and then
again to stop the video.
-Pressing the right side of the pedal will take still pictures. You can take pictures while recording
as well.
(Note, if your device has a USB C port
you must use a USB C to USB A
adapter, also you may require a USB
hub if your device only has one USB
port
Record/Stop
Take Picture

NanoCam 4K/NanoCam Quick Start
-To adjust your camera’s settings click on the
camera settings button on the bottom right
of your screen
-In the camera settings window, click on
Advanced settings to open up all of the
parameters for the camera
-In Advanced Settings you will see two tabs,
Video Proc and Camera Control
-If an undesired change is made, the settings
can be put back to Default by clicking the
button
Part C: Setting up the Camera
Part D: Software Settings
Use Blue Cap Driver to Tighten nut
Clockwise to lock camera in place
T-Mount for Headlight

NanoCam 4K/NanoCam Quick Start
-When a change is made to any
setting, you must click Apply to
save the changes
-To adjust Exposure in the
Camera Control Tab first
1. Uncheck the Auto Box
2. Adjust the exposure to the
desired value
3. Click the Auto Box again,
there should be a check
mark
4. Click Apply
Suggested Blue Light Settings:
NanoCam 4K
-Exposure should be at -10
-Auto Exposure box checked
NanoCam Go:
-White Balance On Auto in
the main camera settings
window (value 4600)
-In the Camera Control Tab,
exposure should be at -7
-Auto Exposure checked