Dextra Verteco 3 User manual

Verteco 3 Installation
DIL-0149-0001 Revision - F 18/07/2019
230-240V / 50-60Hz
IP20
IK00
WARNING - THIS LUMINAIRE MUST BE EARTHED
This luminaire has been tested and is manufactured to comply with BS EN
60598 : specification for general requirements and tests. It should be installed by
a suitably qualified person in accordance with IEE.
CAUTION: there is a potential risk of electric shock from the LED boards when
the product is operational with the cover removed.
NOTE: INSTALLATION AND OPERATION OF THE LUMINAIRE BEYOND ITS
SCOPE OF SUPPLY WILL INVALIDATE THE WARRANTY.
DIL-0149-0001
1.
2.
3.
4.
5.
6.
Trunking Mount Options
Slide the mount brackets out as shown below.
5050 Trunking
Use the brass bush
and black plastic
spacers supplied with
the luminaire to
secure to mount
brackets similar to that
shown here. (Brackets
supplied by others).
Direct Trunking Mount
Various trunking mount
options are available.
The mount brackets in
the luminaire are
compatible with Canalis,
Zucchini and standard
50x50 trunkings. Please
enquire if you are unsure
whether the Verteco 3
can be mounted to your
trunking.
(Brackets supplied by
others)
Lightrak KNX
Trunking
Secure the trunking
mount brackets to
the slide out
brackets using the
screw, nut and
plates provided.
(Bracket supplied by
others)
Attach the luminaire
to the trunking using
the mount brackets.
Close the latch on
the mount bracket.

Verteco 3 Installation
DIL-0149-0001 Revision - F 18/07/2019
7.
8.
9.
10.
11.
12.
13.
14.
Using the plug supplied, connect the
mains cable into the panel mount in
the side of the body.
Commission luminaires as required.
Insert locking screw
into the bracket as
shown to ensure the
luminaire is securely
attached to the
trunking.
Always ensure safety tethers (supplied) are threaded
through the suspension holes in the rear of the fitting
before moving on to subsequent fittings.
Suspended
NOTE: NOT RECOMMENDED FOR
CHAIN OR NON-RIGID FIXING
WHEN USED WITH SENSOR
(Suspension kit supplied
separately)
Suspend fitting by 2x suspension
Holes on rear of fitting.
Surface Mounted
Slide the mount
brackets out as
before.
Using the two black plastic spacers provided, secure the
fitting directly onto the surface using 4x suitable screws
each end (not provided).
Suspension toggles
to be inserted into
the two 7mm holes
as shown.