Coolon WDN-140 User manual

Page 1 / 2WARDEN LED LUMINAIRE MANUAL EDITION 0.5
ASSEMBLY KIT
WDN-140
285mm 205mm
658mm
The assembly kit includes the following components
Wall Mount Bracket
Mounting Hardware
Power Supply & Enclosure WDN-140 LED Luminaire
+ +
6X M8 nyloc nuts
6X M8 washers
(4 sets used for mounting and 2 spare)
2X M6x20 hexagonal cap screws
for power supply lid supplied as spare
2X Zip Ties
1X 12x9.2 plastic grommet
1X M10 nylock nut
1X M10 washer
1X M10 Nord-Lock washer
1X M10x25 hex bolt
Page 1 / 2[email protected] • aus. 1300 287 533 • intl. [phone] • www.coolon.com.au
Product must be installed by a suitably qualied person. All documentation is subject to change without notice. Refer to our website for the latest information.
www.coolon.com.au

A
B
C
Ø10mm
Ø10mm
Ø20mm
Step 2
Mount the luminaire (A) and feed the cable through the grommet provided
(B) and secure into the cable retaining clip (C) on the bracket.
Step 3
Mount the power supply enclosure to the wall mount bracket using the
four M8 nylock nuts and washers.
Step 4
Feed the cables through the cable glands and connect as shown below,
making sure polarities are adhered to. Once the cables are positioned as
required secure the cable gland nut sufciently for an adequately
sealed connection.
Step 5
The power supply enclosure can now be closed and secured using the eight
M6x20 hexagonal cap screws.
Page 2 / 2
MOUNTING INSTRUCTIONS
Step 1
Mount the wall bracket using the slots provided
240 VAC
Cable from luminaire
- +N E L
N L
- +
WARDEN LED LUMINAIRE MANUAL EDITION 0.5
Nord lock washer &
Nylock nut
M10x25 hex head bolt &
M10 at washer
Page 2 / 2[email protected] • aus. 1300 287 533 • intl. [phone] • www.coolon.com.au
Product must be installed by a suitably qualied person. All documentation is subject to change without notice. Refer to our website for the latest information.
www.coolon.com.au