DigiFarm AGCO C1000 Reference guide

MD5007
rev 6
DigiFarm Technical Support
319.531.7574
[e-mail]
DigiFarm
Quick Reference Card
AGCO C1000 & RV50
AGCO C1000 Display Setup
1 Connect the RV50 cable to the AGI 4 via the
adapter cable and black connector on the back of
the receiver
2 Navigate to the Wrench icon, then System, then Correction level
3 Select Cellular Network; checkmark “Use external radio”; then select the checkmark on the right
4 Set the Correction type to
“RTCM3.X”; Serial Port to “D”; Baud
Rate to match the Beacon; Parity to
“None”; & NMEA Rate to 10
seconds

MD5007
rev 6
DigiFarm Technical Support
319.531.7574
[e-mail]
DigiFarm
Quick Reference Card
AGCO C1000 & RV50
*Note- If this unit was ordered with a subscription, it will be preprogrammed and plug and play ready.
The following instructions will not be needed.
Log into the device via WAN static IP (166.XXX.XXX.XXX:8080) or LAN connection (192.168.1.1:8080) on Port
8080.
Username: digifarm
Password: digifarm
You will then be directed to the page shown below. On this page you can select a receiver preset based on
the receiver type you have, then enter your username and password. Save device info at the bottom then
select the reboot icon at the top of the screen.