Digilin Cobra User manual

Cobra –Exterior LED Wall Fixture
Installation Guide
Document Rev: 6.0 - 24 January 2022
Product specifications are subject to change without notice
digilin.com.au ©2022 Digilin Technologies
[phone] Page 1 of 2
Notes
•Installation should only be performed by a qualified professional
•Install in accordance with all appropriate wiring standards
•DALI is not SELV and needs to be wired accordingly
•Never connect a LED fitting to a driver that is powered. Doing so may result in damage to the LED.
•Always make sure the output voltage range and output current of the LED driver match the requirements of the LED
fitting. Failure to do so may result in damage both the driver and fitting.
•The light source of this luminaire is not replaceable; when the light sources reach its end of life the whole luminaire
shall be replaced.
•Do not install under mechanical stress.
•Allow for expansion due to changes in temperature.
•Please be aware that while the system has a very long operational life, faults may still occur, and provision needs to be made for maintenance.
•Always turn off power before working on fitting.
•Warranty void if damage is caused by water ingress through cables. Cable join must be sealed or in a dry location.
•This is an extra low voltage product
•Avoid excessive strain on the fitting cable fixing during installation. Take care not the nick or damage the cable. Always terminate in a dry location or
use a suitable sealed connection.
•We recommend either that full unjoined cables be used (back to a dry location) or a suitable weatherproof joining method be used.
•There are many standard ways that fully waterproof reliable connections can easily be made if a loop wiring system is required. These include electric
junction boxes that are filled with one of the readily available potting encapsulates specifically made for this type of application.
Specifications
Physical
U n i t s
Dimensions
39.2 x 39.2 x 93
mm
From Mounting Surface
51.5
mm
Mounting Plate Diameter
62
mm
Mounting Holes (from centre)
23
mm
Mounting Screw Hole
Diameter
5.5
mm
Weight
580
g
 


Cobra - Exterior LED Wall Fixture
Installation Guide
digilin.com.au
[phone] Page 2 of 2
Installation
1. Install drive gear in a dry location.
2. Prepare mounting surface by drilling central
hole for cable and 2 holes for mounting
fasteners.
3. Feed fitting cable through central hole.
4. Run cable to dry location for any joins and
connect to drive gear.
5. Ensure correct orientation of fitting then
secure to surface using appropriate
fasteners.
6. Turn on power.
Wiring Diagrams
Non-Dimmable (NDM)
Non-Dim fittings are wired in parallel.
Dimmable (DIM)
Dimmable fittings are wired in series.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at www.digilin.com.au
















