Digital Watchdog DWC-MT9JUNC User manual

DWC-MT9JUNC
Junction box for fixed lens turret cameras
Quick Start Guide
Tel: [phone]
Technical Support Hours: 9:00AM – 8:00PM EST, Monday through Friday
digital-watchdog.com
NOTE: Download all your support materials and tools in one place.
1. Go to: http://www.digital-watchdog.com/resources
2. Search your product by entering the part number in the ‘Search by Product’ search bar. Results
for applicable part numbers will populate automatically based on the part number you enter.
3. Click ‘Search’. All supported materials, including manuals
and quick start guide (QSGs) will appear in the results.
WHAT’S IN THE BOX
Mounting Screws and Anchors (6.5x38mm, head diameter 12mm) x4
Waterproof Rings for Mounting Screws x4
Mounting Template x1
Camera Mounting screws (PM4x10mm, head diameter 6.6mm) x4
Cable Gland Connector x1

Quick Start Guide
Rev: 12/21
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
INSTALLATION
1Separate the mounting plate from the junction box base by loosening the four (4) screws.
2Using the mounting template or the junction box base itself, mark and drill the necessary holes on the
mounting surface.
3Secure the junction box base to the mounting surface using the screws and anchors that were included
with the junction box.
4
Connect the mounting plate to the junction box’s base using the included screws (from INSTALLATION
Step 1).
4
Connect the camera to the junction using the included camera mounting screws.
5Make all necessary cable connections to the camera and arrange the cables in the junction box base. Use the waterproof cap
and gasket with the network cable to reduce the risk of water leaks. See the camera’s QSG for more information.
7Adjust the camera’s position and angle by loosening the lock screw at the base of the camera. When the camera’s desired
position is achieved, secure the lock screw back in place to complete the installation.