Digital Watchdog DWC-D6351D User manual

10252013
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
Indoor Dome Camera
DWC-D6351D
DWC-D6351DB

2
PRECAUTIONS
Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages.
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera.
It can cause fire, short-circuits, or other damages.
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of kitchen or a boiler room,
as the temperature may rise to high levels.
Cleaning:
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface:
The material of the mounting surface must be strong enough to support the camera.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference, when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
WARNING: Changes or modifications are not expressly approved by the manufacturer.

Troubleshooting
Warranty Information
Specifications
12
13-14
15
Table of Contents
3
TABLE OF CONTENTS
Introduction
Installation
Features
Parts and Descriptions
Dimensions
Inside the Box
Installation Instructions
Connecting to Monitors
4
5
6
7
8-9
10
Adjusting the Camera Angle 11

4
FEATURES*
1/”3 CMOS Sensor
600 TV Lines [B/W], 580 TV Lines [Color]
3.6mm Fixed Lens
Electronic Day & Night
DRC (Dynamic Range Compressor)
2D DNR (2D Digital Noise Reduction)
HME (Highlight Masking Exposure)
SLC (Side Light Compensation)
Available in Charcoal and Ivory color Models

5
PARTS & DESCRIPTION*
1Bottom Case
Camera Gimbal
Upper Case
Dome Cover
2
3
4
1
2
3
4

6
DIMENSIONS IN MILLIMETERS (IN)*
90.0 3.54”
37.6 1.5”
68.5 2.70”
30.9 1.22”
8.0 0.31”
5.0 0.20”
67.0 2.64”
90.0 3.54”

7
INSIDE THE BOX*
Included with Camera
1
2
3
User Manual
Mounting Template
2 Machine Screws and 2 Dry Wall Anchors
09112013
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
Indoor Dome IR Camera
DWC-D6351D
DWC-D6351DB

8
EASY INSTALLATION*
camera

9
INSTALLATION INSTRUCTIONS*
1. Use the camsera or mounting template
to mark and drill the necessary holes in the
wall or ceiling.
2. Pull wires through and make
connections.
3. Using the two (2) included screws,
mount and secure the camera to the wall
or ceiling.
4. Adjust the camera’s Pan and Tilt. See
page 11 for more information.
5. Snap the camera’s cover dome to the
camera base to complete the installation.

10
Use the diagram below to connect to a Monitor or CRT Monitor properly.
12VDC
CCTV Monitor
Power Connection - 12VDC
CONNECTING TO MONITORS*

11
ADJUSTING THE CAMERA GIMBAL*
1Rotation 360º 2Panning 360º
3Tilting 75º
Non IRNon IR
Non IR

12
FOR NO VIDEO
FOR OUT-OF-FOCUS VIDEO
Before sending your camera for repair, check the following or contact our technical
specialist.
Check the coaxial cable and make sure it is connected securely.
Check the power supply and make sure the camera has the proper voltage and
current.
Check the clear dome cover and the lens for dirt or fingerprints. Use a soft cloth and
gently clean. Check the lens’ manual focal and zoom adjustment. The use of a field
test monitor is recommended.
TROUBLESHOOTING

13
WARRANTY INFORMATION*
Digital Watchdog (referred to as “the Warrantor”) warrants the Digital Watchdog Camera
against defects in materials or workmanship as follows:
LABOR: For the initial two (2) years and one (1) year on IR LED from the original
purchase date, if the camera is determined to be defective, the Warrantor will repair or
replace the unit with a new or refurbished product at its option at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for the initial two (2)
years and one (1) year on IR LED.
To obtain warranty or out of warranty service, please contact a Technical Support
Representative at 1-866-446-3595 Monday through Friday from 9:00AM to 8:00PM
Eastern Standard Time.
A purchase receipt or other proof of the original purchase date is required before
warranty service is rendered. This warranty only covers failures due to defects in
materials and workmanship which arise during normal use. This warranty does not
cover damage which occurs in shipment or failures which are caused by products not
supplied by the Warrantor or failures which result from accident, misuse, abuse,
neglect, mishandling, misapplication, alteration, modification, faulty installation, set-up
adjustments, improper antenna, inadequate signal pickup, maladjustment of consumer
controls, improper operation, power line surge, improper voltage supply, lightning
damage, rental use of the product or service by anyone other than an authorized repair
facility or damage that is attributable to acts of God.

14
LIMITS & EXCLUSIONS*
There are no express warranties except as listed. The warrantor will not be liable for
incidental or consequential damages (including damage to recording media without
limitation) resulting from the use of these products or arising out of any breach of the
warranty. All express and implied warranties, including the warranties of
merchantability and fitness for particular purpose, are limited to the applicable
warranty period set forth above.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, or limitatons on how long an implied warranty lasts, so the exclusions or
limitations listed above may not apply to you. This warranty gives you specific legal
rights, and you may also have other rights that vary from state-to-state.
If the problem is not handled to your satisfaction, then write to the following address:
Digital Watchdog, Inc.
ATTN: RMA Department
5436 W. Crenshaw Street
Tampa, FL 33634
Service calls which do not involve defective materials or workmanship as
determined by the Warrantor, in its sole discretion, are not covered. Costs of such
service calls are the
responsibility of the purchaser.

15
SPECIFICATIONS*
Lens Type Fixed Lens
ENVIRONMENTAL
LENS
ELECTRICAL
MECHANICAL
VIDEO
Image Sensor 1/3” CMOS Sensor
Total Pixels 728 (H) X 488 (V)
Minimum Illumination F1.2 (30IRE): 0.17 Lux [Color]
F1.2 (30IRE): 0.06 Lux [B/W]
Horizontal Resolution 600 TV Lines [B/W], 580 TV Lines [Color]
S/N Ratio 52dB (AGC off)
Scanning System 2 : 1 Interlace
Synchronization Internal
Video Output CVBS: 1.0Vp-p / 75 Ω
Focal Length 3.6mm
Operating Temperature -10
o
C ~ 50
o
C (14
o
F ~ 122
o
F)
Power Requirement DC12V
Power Consumption DC12V: 0.8W, 66mA
Operating Humidity Less than 90% (Non-Condensing)
Housing Material Plastic
Dimensions Ø 90 X 68.5 mm (3.54 x 2.7 Inch)
Weight 0.028 lbs
Frequency 15.734KHz (H), 59.95Hz (V)

5436 W Crenshaw St. Tampa, FL 33634
Tel : [phone]
Fax : [phone]
www.Digital-Watchdog.com
[email protected]
Technical Support Hours : Monday-Friday
8:30am to 8:00pm EST