DigiTrak FSD User manual

1
Power On Remote Display
1. Install the battery pack or
connect to a DC power source.
2. Connect antenna.
3. Press Execute for two
seconds; display enters the
Remote Mode locating screen.
4. Press the Down arrow to
access the Main menu.
Remote Display Main Menu
Use the arrow buttons to highlight menu options and
Execute to select. Use the Remote Mode locating screen
during drilling.
Settings
Use the Settings menu to set the following items:
Telemetry channel
Receiver model
Telemetry frequency designation
Depth units
Pitch units
DCI recommends setting the units (m, degrees) to match
those on the receiver.
© Apr 2015 Digital Control Incorporated
All rights reserved. 402-1012-21-A metric 9/2 www.DigiTrak.com
Arrow
buttons
Execute
button
Settings
Remote Mode
Power off
F Series
Display
(FSD)

FSD
™
Quick Start Guide

2
Remote Mode Locating Screen
This screen shows the data the transmitter (Tx) is sending to the
receiver.
Target Steering
When Target Steeringmode is activated on the receiver, the FSD
screen changes automatically to show depth and distance data for
the steering target. Refer to your FSD operator's manual for
important details on how to steer the indicator to the target.
For detailed information, see the FSD Operator’s Manual, available at
www.DigiTrak.com. If you have questions, contact your regional DCI office
or U.S. Customer Service at 1.425.251.0559 or 1.800.288.3610 US/CAN.
Watch our DigiTrakTraining Videos at
www.youtube.com/dcikent
DIGITAL
CONTROL
INCORPORATED
Telemetry
update meter
Tx pitch
Tx roll
Tx temp.
Battery status
Telemetry channel
Tx battery strength
Horizontal distance
between transmitter
and receiver
Approximate transmitter
depth
Steering indicator
Target
Transmitter roll
Transmitter pitch