DIHL KA-HWD02 Series User manual

USER GUIDE
Contents
Introduction
Parts Included
Important Safeguards
Using the Appliance
Cleaning
Technical Specifications
Environmental Info and Support
1
1
2
2, 3
3
3
4
Hot Water Dispenser
KA-HWD02 Series

1.
2.
3.
4.
5.
6.
7.
8.
9.
On/off switch
Water spout
Drip Tray
Clip to hold drip tray higher
Water tank lid
Maximum fill level indicator
Minimum level indicator
Drainage cap
Reset key
2
4
3
8
6
5
1
Introduction
Congratulations on your new purchase and thank you for choosing Dihl.
Your new Dihl instant kettle allows you to make a hot drink almost instantly. Read this user manual
carefully before you use the appliance and save it for future reference.
PARTS INCLUDED
9
1

Caution
Preparing for use
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
1.
2.
3.
4.
5.
6.
Read all instructions carefully before use.
Before first use, check to ensure the voltage indicated on the unit corresponds to the voltage of your
home.
Do not operate the unit if the water is below the minimum level as this will cause damage to the heating
element.
Do not let the cord hang over the edge of a table or counter, and keep away from hot surfaces or naked
flames.
Do not put the appliance in the refrigerator.
Do not lean the appliance or operate it upside down.
For indoor, domestic use only.
This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
The unit is not intended to be operated by means of an external timer.
Keep away from children. Do not allow children to play with the unit.
To prevent electric shock or other injury, never immerse the appliance in water or any other liquid, nor
rinse it under the tap.
Do not touch the hot surface or water spout when in use.
Do not block the steam outlet or open the water tank lid while the appliance is in use.
Do not use the appliance to heat anything other than water.
Do not fill the water jug above the maximum level.
Place on a flat surface.
Plug the unit into the mains and ensure it has power.
Clean thoroughly before first use.
Fill the water tank and operate several times before first use.
Place a cup on the overflow tray.
Press the ‘ON’ button once to dispense 200ml of water. The LED button will turn blue.
IMPORTANT SAFEGUARDS
USING THE APPLIANCE
2

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Press twice and the water will dispense continuously, the LED button with turn red.
Press the button again to stop the flow of water.
The unit will cut out when there is insufficient water. Turn off the power switch to automatically prevent
water from being dispensed when the water tank is refilled.
When the water overflow tray is full, allow the water to cool before removing the tray and pouring away.
Always reattach the water overflow tray before continuing use.
Always switch off and unplug your water dispenser and allow it to completely cool before
cleaning.
Do not immerse the unit in any liquid.
Wipe the outside of the appliance with a clean, damp cloth.
Clean the appliance with hot soapy water and a non-abrasive sponge.
To maintain performance, descale the appliance monthly. To do this, add some detergent to hot
water and operate the unit at least three times. Rinse thoroughly with clean water before using
again.
To clean the reservoir, remove the rubber stopper plug at the base of the unit and empty any
residue water. Wash with a clean, damp cloth and replace the rubber stopper securely before
reusing.
TECHNICAL SPECIFICATIONS
CLEANING
KA-HWD02
2200-2600 W
Hot Water Dispenser
220–240 V
50/60 HzFrequency
Model
Product Name
Voltage
Rated Power
3

Storage
Do not throw away the appliance with the normal household waste at the end of its life; hand it in at an official
collection point for recycling. By doing this, you help to preserve the environment.
There may be occasions when the built-in thermostat cuts power to the device due to abnormal
operating conditions.
If you discover that the device is no longer boiling water on demand, try pressing the reset button
located on the front of the unit.
Environment
Thermostat Reset
If you need more information or if you have a problem, please contact Dihl at [email protected]. If you have
purchased your item from another retailer, please contact them directly.
Support
1.
2.
Unplug the appliance and let it cool down.
Make sure all parts are clean and dry.
To view our entire product range, visit
www.dihl.co.uk
value
quality
no compromise
ENVIRONMENTAL INFO AND SUPPORT
4