DIMAX GROUP Könner & Söhnen KS-B1A User manual

Please read this manual
carefully before use!
Automatic Battery Charger
Owner’s Manual

І. INTENDED USE
This automatic battery charger is intended for charging 6
V / 12 V lead-acid batteries. It is used to charge batteries of
generators, cultivators, motorcycles, snowmobiles, boats, four-
wheelers, etc., with a capacity of up to 32 A/h.
After selecting the required voltage, the charging process
is carried out automatically.
II. INSTRUCTIONS FOR USE
Power
indicator
Fault
indicator
12 V
indicator
Mode
selection
button
6 V
indicator

1. Getting started. Connect the red terminal to the “+” side of
the battery and the black terminal to the “-” side of the
battery and then connect the charger to the mains supply.
When the charger is plugged in, the power indicator lights
up green.
2. Press the MODE button to select the appropriate charging
voltage that matches the battery's rated voltage: select 6 V
charging voltage for a 6 V battery and 12 V charging voltage
for a 12 V battery. The selected mode will turn green.
3. The charger will automatically enter the charging mode. If
the voltage at the battery terminals is more than 2 V, the
power indicator will flash green. If the voltage is less than
2 V, the charging process will not start.
4. When the battery is fully charged, the charger will
automatically enter trickle charge mode and the power
indicator will light up green.
5. Before disconnecting the battery, unplug the charger from
the mains supply and then remove the terminals from the
battery.
6. If the battery is faulty, the fault indicator will go on.
WARNING!
Use the correct charging voltage according to the battery's rated
voltage!
Do not charge the battery when the engine is running!
III. SAFETY FUNCTIONS
1. Short circuit protection. The charger will automatically
power off if the terminals are short-circuited.
2. Overtemperature protection. The charger powers off in
two situations, as described below, and automatically enters
the charging mode when the operating temperature is
restored:
a) when the charger has been exposed to high temperatures
for a long time;
b) when the temperature inside the charger exceeds the
operating temperature.
3. Spark protection. The terminals are not energized until the
battery is connected.

IV. SPECIFICATIONS

V. TROUBLESHOOTING

VI. RISK OF EXPLOSION
1. Do not use an acid battery near open flame as it emits
explosive gas during charging. Read the instructions
carefully before use.
2. To reduce the risk of battery explosion, follow the battery
instructions provided by the device manufacturer and
ensure a well ventilated area during charging.
VII. NOTES:
1. Please read the owner's manual carefully before use.
2. Please do not dismantle the charger.
3. The charger may become hot during operation.
4. Do not use the charger in rain or wet environment.
5. Please keep the charger out of the reach of children.
6. Be sure to check the power cord before use and make
sure it is not damaged. Do not use the charger with a
damaged power cord or case.
7. Never charge a damaged or frozen battery. It is
dangerous.

NOTES
The current list of service centers can be found on the official
importer's website:
ks-power.de/en

CONTACTS
Germany
Poland
Ukraine