
- Step 2. Unscrew the vapor tip. Remove the reclaim chamber and mouthpiece. If you are
unable to unscrew the vapor tip, there may be concentrate in the threading. If this
happens, grip the vapor tip with pliers, and turn to get started.
- Step 3. Place the vapor tip, mouthpiece, and reclaim chambers in a small cup. Pour on
enough 90 plus percent isopropyl alcohol to cover them. Let soak for at least 30 minutes.
- Step 4. Meanwhile, use a cotton swab soaked in the alcohol to clean the vapor tip
connection point and airway.
- Step 5. Remove the pieces from the alcohol. Rinse with warm soapy water and dry. Do
not rinse the battery, and do not soak the battery.
- Step 6. Reattach the reclaim chambers, vapor tip, and mouthpiece before attempting to
use your little dipper. Make sure the reclaim chamber with the larger hole goes on the
vapor tip side.
Safety.
Read the following safety recommendations before using Little Dipper.
- The vapor tip gets hot. Do not touch it while using the product or for at least three
minutes after use.
- Do not use little dipper while charging.
- Only use the vaporizer with legal, safe, and natural concentrates.
- Never touch the vapor tip to anything other than concentrate. Especially individuals,
flammable surfaces, or your concentrate container.
- Do not expose little dipper body to water or other liquids.
- Do not attempt to use little dipper if the battery has been exposed to water.
- Be sure to turn little dipper off when you are done using it. To do this, click the button 5
times quickly.
- Improper use, changes, or modifications to little dipper could cause damage to the
device or cause physical harm.
Troubleshooting.
If you’re having trouble with your Little Dipper, go to dipdevices.com/support, reach out at
What do I do if my Little Dipper clogs?
The easiest way to clear the Vapor Tip is by turning the power setting to high. Press the button 3
times, when already on, until you reach the high setting. Then, while holding the Little Dipper
Vapor Tip over your concentrate container, hold the button for 10 to 15 seconds so the coil gets
hot and melts the residue blocking the airflow. Then immediately hold the button down again
while pulling air through the mouthpiece until any residue that's blocking the airflow is cleared.