Direct Supply Attendant User manual

Please keep and refer to this Owner’s Manual.
1-800-634-7328 ■directsupply.com
Thank you for purchasing a Direct Supply®Attendant®
Mobile Sphygmomanometer from Direct Supply®
Equipment & Furnishings™. Please read this entire guide
carefully and keep it for future reference. This guide
will provide you with instructions, warnings, warranty
information, and other important information about your
Direct Supply Attendant Mobile Sphygmomanometer.
Share this information with your housekeeping, nursing
and maintenance staff to help ensure the Mobile
Sphygmomanometer is used and cared for properly.
Direct Supply®Attendant®
Mobile Sphygmomanometer
Owner’s Manual

2
NOTE: Indicates a tip.
• Attention. Read the instructions.
WARNING: Calls attention to a potential danger that
requires correct procedures or practices in order to prevent
personal injury.
CAUTION: Indicates correct operating or maintenance
procedures in order to prevent damage to or destruction of
the equipment or other property
DEVICE:Your Direct Supply Attendant Mobile
Sphygmomanometer
YOU andYOUR:The facility, community or other entity that
has purchased the device.
WE, US, and OUR: Direct Supply Manufacturing, Inc.
Definitions and Symbols

1-800-634-7328 ■directsupply.com 3
Safety Notices – Warnings and Cautions
Read and follow all directions and warnings before using this
device. Do not operate this device without first reading and
understanding this user manual. Damage, injury or even death
may result from improper use of this device or not following
directions and warnings.This device is intended for use by
trained and licensed healthcare or senior care providers in
normal, indoor conditions.
• WARNINGS:
• Donotinatebladdergreaterthan300mmHg.
• Donotkeepbladderinatedanylongerthannecessary.
• CAUTIONS:
• Donotdrop,strike,orpullexcessivelyontheMobile
Sphygmomanometer components.
• Donotexposethebloodpressurecufftodirectsunlight.
• DonotlettheMobileSphygmomanometerincontactwith
sharp objects which could pierce the material and cause
damage to the device.
• DonotdisassembleyourMobileSphygmomanometer.
• Alwaysdeatethebloodpressurecuffcompletely
before storage.
• Nonotuseahotirononthebloodpressurecuffs.
• Donotusesteam,heatorliquiddisinfectantstocleanthe
cuff,inationsystem,ormanometer.Gassterilizationmay
be used on the cuff only, if necessary.
Safety Notices –
Warnings and Cautions

4
Assembly
Toolsneeded:6mmhexwrench(provided),3mmhexwrench
(provided),#2Phillipsheadscrewdriver(notprovided)
• WARNING: Unpack the Direct Supply Attendant Mobile
Sphygmomanometer in an area with sufficient room to
work. Do not allow residents near the device until it has
been completely set up and the work area has been cleared
of all debris. Inspect the device for damage. If the device is
damaged or the wrong device was accidentally sent, DO NOT
USE IT and immediately contact Direct Supply Equipment &
Furnishings for further instruction.
1. With base on its side connect upright outer sleeve to
thebaseusing6mmhexnutandlockwasherasshown.
Tightenwiththe6mmhexwrench.Tightenthehexnut
securely.Turn the base upright and insert the spring into
the upright sleeve.Then place the stainless steel tube into
the upright sleeve with the open end facing up.
2. Loosenthehexnutonthecollarofthecuffstoragebasket
withthe3mmhexwrenchprovided.Placethecuffstorage
basket atop the stainless steel tube. Make sure the tube
goescompletelyinsidethecollarandtightenthehexnut.
3. Attachtheplatetothemanometergaugeusingthesmall
Phillipsheadbolts(x2),matchingwashers(x2),and
matchingnuts(x2).
4. Attach the manometer gauge assembly to the cuff storage
basketandsecurewiththelargehexbolt(usingthe6mm
hexwrench),washer,andnut.
5. Attach coiled tubing to air inlet of manometer gauge. Insert
“male” connector of coiled tubing into the “female” connector
on the bladder tubing. Fold cuff and store in the basket.
6. The height of the manometer gauge can be adjusted by
loosening the knob at the top of the black upright sleeve, moving
the tube to the desired height, and re-tightening the knob.

1-800-634-7328 ■directsupply.com 5
1
3
2
2
4Attach the main unit
of the clock to the cuff
storage basket
Cuff storage basket
Place cuff storage
basket atop stainless
steel inner tube
InnerTube
Spring
Making sure the tube
goes completely
inside the collar
The Collar
SpiderLeg
Adjusting Knob for
adjust at desired
height of clock gauge
Baseofxationplateusedfor
mobile clock aneroid model only
and attached to the cuff storage.
ExtendedTubingwithmetalconnector