DirecTV D2 Advantage Lite Instruction Manual

Installation and Troubleshooting Guidelines

What is D2 Advantage™ Lite?
D2 Advantage Lite (D2 Lite) is a compact, centralized SWiM
distribution system designed to service small MDU buildings
that are 20 units or less. It eliminates the need to install
individual dishes while providing the full range of DIRECTV
services; including over 190 full-time HD channels, multi-room
viewing capabilities, DIRECTV On Demand, MediaShare, local
channels and international programming.

Advantages of D2 Lite
A simple, centralized distribution system
Enhance building appearance without the clutter of multiple satellite dishes
Only one dish required per building
Residents only require the installation of a set-top box
Efficient and cost effective installation
No need to access individual units when installing a centralized distribution system
Installation is simplified by utilizing existing technology and components
Reduces overall equipment and labor costs vs. traditional MDU and Dish on Balcony
System is powered from each activated unit, eliminating the cost and need for external
power outlets
Multiple programming packages and agreements
Residents are eligible for nationally offered rates
Residents are billed directly for their programming packages, equipment and services

D2 Lite Components
The D2 Lite enclosure is a self-contained unit that houses the SWiM distribution
parts required to successfully install a customer. The enclosure utilizes common
components that are already deployed throughout the DIRECTV network.
Slimline KaKu ODU
SL5 LNB
World Direct International ODU

D2 Lite Components Continued
SWiM16 Module
Band Stop Filter
MDU version
PI-29z Power Inserter

D2 Lite Enclosures
There are two (2) versions the D2 Lite enclosure
The key change is the removal of the Band Stop Filters and assorted connections located in
the enclosure
The V2 enclosures require that a Band Stop Filter be installed on each APMT FEED as the
unit homerun is installed and activated
Failure to install the Band Stop Filters will cause service issues with existing installed
customers and constitute a failed installation at inspection requiring a truck roll to resolve
Version 1:
Band Stop Filters
Installed
Version 2:
Band Stop Filters
Not Installed

D2 Lite System Components V1
D2 Lite Enclosure V1
Holland HRD2 Splitters
Band Stop Filters
SWiM16 Module(s)
Green Label SWiM Splitters
Mini RG6 Coax Cabling

D2 Lite System Components V2
D2 Lite Enclosure V2
SWiM16 Module(s)
Mini RG6 Coax Cabling
Holland HRD2 Splitters
Green Label SWiM Splitters

D2 Lite SWiM Module Ports Assignments
APMT FEED ports 1, 2, 3, 4 are fed from SWiM module #1 (bottom SWiM module)
APMT FEED ports 5, 6, 7, 8 are fed from SWiM module #2 (top SWiM module)
D2 Lite (V1 & V2) can accommodate up to 2 SWiM16 modules, for a total of 32 SWiM
tuners, in a single enclosure. The enclosure is shipped with one SWiM16 module fully
installed and is pre-wired for one additional SWiM16 module. There are a total of 8
output ports available for use. The ports are labeled APMT FEED 1,2,3,4,5,6,7,8
The ports with a “ * ” next to them are wired to the SWiM splitters installed in the enclosure and
will have a signal level approximately 4.5dBm lower than the other ports due to the loss of the
SWiM splitter. These ports should be connected to the units with the shortest homerun lengths.

D2 Lite Site Qualification
When arriving at a property that may qualify for a
D2 Lite installation there are a few simple questions
to ask before proceeding with any work on the
property
Is the building between 2 and 20 units in size?
Do I have landlord permission?
Is there line of site for an ODU?
Is there already a D2 Lite enclosure installed?
If a D2 Lite enclosure is already installed, the property does not
have to be re-qualified and the customer installation can be
completed
Is there a suitable location to install a D2 Lite enclosure?