Disty distybox300 Installation guide

v
English
FAQs
The most common questions – answered at a glance
1. Telekom Speedport Smart 3
Problem: Device cannot be logged in. The router should have the rmware
update (status 9/2019): 010137.3.5.000.1 or newer!
2. Change distybox300 settings
Normally, it is absolutely sufcient if you use distybox300 in your router or
the DECT base station. No further parameters need to be changed, it does
not matter whether you use VOIP phone or fax, book in and you‘re done.
There are only a few exceptions that require parameter changes.
3. Can the distybox300 also be operadet with a VOIP port?
The type of mains connection is not relevant for the operation of distybox300.
It works on all networks.
4. No analog phone at hand?
You no longer have an analogue telephone to set parameters of distybox300?
No problem: You can set all the dialing procedures via the the keyboard of your
multifunction device.
5. Fax is not transmitted or not
transmitted completely!
Everything is set up correctly, but incoming or
outgoing faxes are not or only incompletely
transmitted?
Please reduce the transmission speed of your
fax machine (baud rate) as much as possible.
distybox300
www.disty.de
09/2019

v
English
www.disty.de
09/2019
6. New router or new DECT base station
You have received a new router and you want to book in your distybox300 on
this router? (This instruction applies to every new DECT base station.)
To book in distybox300 at a new router or DECT base station, you have to reset
distybox300 rst, this happens as follows:
Please connect distybox300 either with an analog telephone or with your
multifunction device. Then interrupt distybox300 power supply for 5 seconds.
Now dial **990# on the telephone keypad or the fax keypad in the multifunc-
tion device and wait for a short acknowledgement tone. distybox300 is now in
its delivery state and can be re-registered according to the operating instructions.
7. After successfully booked in distybox300 you cannot make
a phone call or fax?
There are constellations of network connection and DECT base stations/routers
which require a different dialling procedure to reach the called subscriber, the
so-called block dialling.
Please change three parameters within your distybox300 in order to dial by
block dialling in the future. How this is done is explained in the additional manual
“Operating instructions for the expert” on page 12, which can be found under
the following link: https://n-hoppe.jimdo.com/english/downloads/distybox-300
8. Can I connect an external bell
to distybox300?
distybox300 supplies 60V to operate an
external bell.
distybox300