3
1. Connect the UBB to a power source (DMG EPS, DMG Battery mount or
any 12 to 30VDC power supply)
2. Connect the Mini Switch or SL1 Switch to the UBB
3.Turn on the UBB by selecting which light you are powering (SL1 or Mini)
Four modes are available:
•LOCAL MODE
•DMX MODE
•Wireless DMX MODE
•CUSTOM MODE
UBB USER MANUAL
LOCAL MODE:
Wireless DMX MODE:
DMX MODE:
Control the UBB remotely with the Wireless DMX protocol.
•Make sure the Wireless DMX antenna is intalled
•Press the dimmer button to enter the DMX start
number of the UBB
•Validate by pressing go
Wireless DMX dot is red when no signal is received, green
when the UBB is connected to a Wireless DMX emitter.
To synchronize with a new emitter, go back to general menu and enter Wireless
DMX mode again.
Control the UBB locally with the dimmer button.
•Press the Switch button to change between CCT and
intensity control
•Press CCT button for a quick change between 3200°K
and 5600°K
•Press the dimmer button to select coarse or ne
intensity tuning
Control the UBB remotely by cable with the DMX protocol.
•Press the dimmer button to enter the DMX start
number of the UBB
CUSTOM MODE:
In custom mode the UBB acts as a translator between
different protocols. It still controls the SL1 Switch or
Mini Switch connected to it.
•Make sure the Wireless DMX antenna is intalled if
sing Wireless DMX.
•Make sure the Wi-Fi antenna is intalled if using Wi-Fi.
•Press the dimmer button to select data input, data
output and DMX address.
•Validate by selecting «Go».
If Wi-Fi input is selected, the UBB creates a Wi-Fi networks with the following
specications:
SSID: UBB serial number
Password: dmglumiere
These informations can be nd in the “info” section of the UBB menu.
Wireless DMX dot is red when no signal is received, green when the UBB is
connected to a Wireless DMX emitter.
•To synchronize with a new emitter, go back to general menu and enter
Wireless DMX mode again.
