DMP Electronics GS-002-DESK User manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
! Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
! Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
Fits most monitor size: 13"-27"
Load weight: 3.3~15.4 lbs (1.5~7 kg)
VESA: 75 x 75 and 100 x 100

Supplied Par ts List
2
(1)Allen Key-n(8)M4 Spacer-m
(5)M6x10 Bolt-i (1)Butterfly Nut-h(1)Support Plate-g
(1)Cable Guide-d (1)Metal Plate-e (1)M8x100 Bolt-f
(8)M4x12
Thumb Bolt-k (8)M4x30 Bolt-l(1)Soft Pad-j
(1) C-clamp-b(1) Dual Arm Set-a (1) C-clamp Brace-c

Step 1A C-clamp Installation/Install Mount at Table Edge
3
i
n
i
n
1.1
1.2
j
1.4
c
1.7
Position 1: 0-52mm
Position 2: 0-82mm
Warning:
Ensure screws are
secured firmly.
!
1.3
Warning:
Ensure screws are
secured firmly.
!
0-82mm
1.5
d
1.6
a

n
Step 1B Existing/Self Drilled Grommet Hole Installation
4
j
1.4
1.1
1.2
i
e
f
1.6
Warning:
Ensure screws are
secured firmly.
!
1.3
Warning:
Ensure screws are
secured firmly.
!
1.5
g
h
Min 8mm

5
Step 2 Attaching the VESA Plate to the Monitor
For Monitor with Curved or
Recessed Back
m
l
Step 3 Sliding the Monitor onto the Head of Dual Arm Set
Install the Security Nut. Make sure
the security nut is installed before
you rotate the monitor.
Slide the monitor onto the head of
Dual Arm Set(a) as shown in the
above diagram.
For Monitor with Flat Back
k
Security Nut

Step 4 Setting the Tilt Angle Position
6
4.1
4.2
4.3
Step 5 Adjusting the Torque of Gas Spring
Adjust the torque of gas spring according to the weight of your monitor. If your monitor
can not stay in the lower position, turn the grub screw clockwise(-). If your monitor can
not stay in the higher position, turn the grub screw counterclockwise(+). Keep turning
until monitor position can be raised and lowered easily.
+
-
n
n

7
Finish Technical Drawings(C-clamp and Grommet)
n
n
Store allen keys
for future use