DMP Electronics LCD923 User manual

English
Installation Instruction
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained herein. Use
proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
! If you don't understand these directions or have any doubts about the safety of the
installation.
! If you are uncertain about the nature of your wall, consult a qualified installation
contractor.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
1

Supplied Par ts List
2
CAUTION!
WARNING
!This TV mount must be securely attached to the
vertical wall. If the mount is not properly
installed it may fall, resulting in possible injury
and/or damage.
Tools Required 4mm Drill Bit
Phillips Screwdriver
10mm Masonry Bit
Carpenter's Level
(1)VESA Plate-b
(1)Wall Plate &
Articulating Arms-a (2)Adapter-c (2)Adapter-d
(2)Lag Bolt-r(2)Lag Bolt Washer-q (2)Concrete Anchor-s (3)Cable Tie-t
(8)M4x10 Bolt-e (8)M4 Nut-g(8)M4 Washer-f (4)M4x12 Bolt-h
(4)M6/M8 Spacer-m (1)Wrench-p(2)Bolt Cover-o(2)M4x6 Bolt-n
(4)M4x30 Bolt-i (4)M6x20 Bolt-j (4)M8x20 Bolt-k (4)M4 Spacer-l

65mm
4mm
Brick Mount
Step 1 Install the Wall Plate to the Wall
3
Wood Mount
60mm
65mm
10mm
a
r
s
q
a
r
q

4
Step 2A
For Flat Back TV For Curved Back TV
This way up! This way up!
hi
l
Attach VESA Plate to the Mounting Hole of TV
For VESA 75x75mm and 100x100mm Mounting Holes
250mm
200mm
100mm
h to k
c
d
e
fg
Step 2B Attach VESA Plate to the Mounting Hole of TV
For VESA 200x100mm Mounting Holes
c
d
c
c
d
d
This way up!
l,m (if necessary)
b
b
b

h to k
This way up!
l,m (if necessary)
Step 3 Attach VESA Plate to the Socket on the Articulating Arm
3.1
3.2
n
3.3
Step 2C Attach VESA Plate to the Mounting Hole of TV
For VESA 200x200mm Mounting Holes
5
200mm
170mm
160mm
200mm
d
c
e
fg
d
c
dc
cd
b

6
Step 4 Adjust the Tilting Angle and Attach the Bolt Cover
p
o
Thank you for choosing our products!
Step 5 Manage Wires with Included Cable Ties
t