Warning: Some TVs may require two people to lift! We are not responsible for personal injury or product damage.
First hook the Monitor Brackets(b) over the top of the wall Plate(a), then let the bottom of the Monitor Brackets rotate to the
bottom of the Wall Plate. This process is shown with the flat mount option in Diagram 4A, and with the minus 5 degree tilt
option in Diagram 4B. Insert the Locking Bar(d) into the slots in the bottom of the Monitor Brackets so that is sits behind
the bottom tab on the Wall Plate. Once the Locking Bar passes out from the other side of wall plate, a padlock can be
added for additional security. Details see Diagram 4C.
4
Attaching Monitor to Wall Plate and Insert the Locking Bar
Step 4
Diagram 4A Diagram 4C
a
b
Brick, Solid Concrete and Concrete Block mounting:
Use the each of Wall Plate(a) as a template to mark 4 hole locations on the wall. Two in
the top row of slots and two more in the bottom row. Make sure these holes are level and
there is at least 6"(150mm) distance between any two holes. Pre-Drill these holes with a
3/8"(10mm) masonry bit to at least 2.4"(60mm) in depth. Insert a Concrete Anchor(w)
into each of these holes. Make sure the anchor is seated completely flush with the
concrete surface even if there is a layer of drywall or other material in front. Attach the
Wall Plate to the wall using 4pcs Lag Bolts(u) and 4pcs Lag Bolt Washers(v), shown in
Diagram 2B.
Wood Stud mounting:
Each of Wall Plate(a) must be mounted to two wood studs at least 16"(406mm)
apart. Use a stud finder to locate two adjacent studs. It is a good idea to verify where the
studs are located with an awl or thin nail. Pre-drill a 2.4"(60mm) deep hole at the desired
height in each stud using a 5/32"(4mm) drill bit. Make sure these holes are in the center
area of the studs and level with each other. Use the Wall Plate as a template to mark the
location of the second hole in each stud. Drill 2.4"(60mm) deep holes using the
5/32"(4mm) drill bit in the marked locations. Attach the Wall Plate to the wall using the
4pcs Lag Bolts(u) and 4pcs Lag Bolt Washers(v).
Connecting the Wall Plate and Mounting the Wall Plate to the Wall
Step 2
Diagram 2A
Thanks for choosing our products, enjoy the using.
Diagram 4B
a
b
c
Choose Mounting Position in plat or minus 5 degree
Step 3
You can mount your television in either of two positions: flat
or at a minus 5 degree downward tilt. To mount the television
flat to the wall use only the Monitor Brackets(b). To mount
the television in the minus 5 degree tilt position you must
first add two Small Added Hook(d) to each Monitor Bracket
with two Carriage Bolts(x) and two Nuts(y) as shown in
Diagram 3.
Diagram 3
y
x
c
b
wall wall
b
d
a
b
z
A
Diagram 2B
u
v
a
w
Determine the proper width you want for wall plate, than insert the Connection Bar(z)
into the slot in the middle of each Wall Plate. Insert the Bolt(A) into the threaded holes in
the connection bar shown in Diagram 2A.
