DOD GUNSLINGER User manual

1 2
3 4
5
6
8
7
1. GAIN - adjusts the amount of distortion gain.
2. LEVEL - adjusts the overall output level of the distortion eect.
3. LOW - adjusts the amount of low frequencies in the distortion signal.
4. HIGH - adjusts the amount of high frequencies in the distortion signal.
5. INPUT - connect your instrument here.
6. FOOTSWITCH - turns the eect on and o.
7. LED - turns on when the eect is enabled.
8. OUTPUT - connect to the next pedal’s input or to the input of your amplier.

USING GUNSLINGER:
Most guitarists/bassists will favor placing the Gunslinger at the
beginning of their chain of eects, so start with that placement.
A typical eects signal chain will consist of Distortion eects rst
then Modulation eects (Chorus, Flanger, Phaser, Tremolo, etc...)
next and then nally Time based eects (Delay and Reverb).
Placing the Gunslinger toward the front of your chain or eects
will preserve the vibe no matter the pedal combination that
follows. That being said you may wish to experiment with
dierent eect placements.
SPECIFICATIONS:
Input 1/4”TS Unbalanced - 470 kΩ
Output 1/4”TS Unbalanced - 100 Ω
Current Draw 20 mA
Bypass True Bypass
Power 9VDC alkaline battery (not included)
HARMAN PS0913DC power adapter (optional)
also compatible with or 18VDC negative center tap PSU
Warranty 1 Year
DOD
10653 River Front Parkway
South Jordan, UT 84095
USA
801-566-8800 Rev A - 6/15