DOM Tronic Mifare User manual

Tronic Mifare
Assembly

Drilling template
ASSEMBLY
Right hand door Le hand door
TRONIC PRO : Drilling template
ø8,1
ø4,5
2,5
To realize housing for
the screw’s head.

Right hand door Le hand door
TRONIC PRO : Drilling template
ø8,1
ø4,5
2,5
To realize housing for
the screw’s head.

Accessories
ASSEMBLY
ø5x29.5
C
D
E F
ø3.5x9.5 Strike plate
M3x18

Right door assembly
ASSEMBLY
ø3.5
ø22
1
A
2
18 + x mm
18 mm
x mm
AA
Section A-A

3
5 6
4
!Warning: Connect blue part
to the side of the legde.
Right door
Right door
Right door assembly
ASSEMBLY

B
12
ø3.5
ø22
Le door assembly
ASSEMBLY
AA
18 mm
x mm
Section A-A

3
5 6
4
!Warning: Connect blue part
to the side of the legde.
Le door
Le door
Le door assembly
ASSEMBLY

1
2
IMPORTANT
The battery pack
(sold separately) must remain
connected during the release
of the batteries. Otherwise,
the internal clock will lose
the time configuration.
Verify that the cable is properly
connected (straight and untill
the bottom).
Verify that the batteries are in
the correct position (as indicated
on the battery holder).

Important notes
ASSEMBLY
3
4
Verify that the latch works smoothly in
and out, without any friction with the
door frame.
Verify that the screws are not
fastened too tightly (<20kgf/cm2).

Batteries
ASSEMBLY
Important
We suggest replacing the batteries
once every three years to ensure
their good condition.
Batteries can deteriorate over time
and damage the lock, especially in
hot environments.
Do not clean the locks with cleaning
products containing hydrochloric acid,
lye or corrosive components,
especially on the metallic parts.
To replace batteries:
1. Connect the battery pack to the lock
through the mini-USB connector,
as shown in the picture.
2. If the lock is closed, input the User
Card (or the Master Card) to open.
3. Replace the old batteries and
discconnect the battery pack.
If the yellow LED blinks
Replace batteries.