Dometic Trim Line 9472 09 User manual

1
TRIMLINESCREENROOM
TRIM LINE
SCREEN ROOM
9472XX.X07
9472XX.X09
INSTALLATION
INSTRUCTIONS
REVISION A
FormNo.3107887.03009/16
©2016 DometicCorporation
LaGrange,IN 46761
USA
SERVICEOFFICE
DometicCorporation
1120 North Main Street
Elkhart, IN 46514
CANADA
DometicCorporation
866 Langs Dr.
Cambridge,Ontario
CANADAN3H2N7
SERVICE CENTER &
DEALER LOCATIONS
Please Visit:
www.eDometic.com

2
TRIMLINESCREENROOM
SAFETY INSTRUCTIONS
This manual has safety information and instruc-
tionstohelpuserseliminateorreducetheriskof
accidentsandinjuries.
RECOGNIZE SAFETY INFORMATION
Thisisthesafety-alertsymbol.Whenyouseethis
symbolin this manual,bealert to thepotentialfor
personalinjury.
Follow recommended precautions and safe op-
eratinginstructions.
UNDERSTAND SIGNAL WORDS
Asignal word,WARNING OR CAUTION isused
withthesafety-alertsymbol.They givethelevelof
riskfor potentialinjury.
indicates a potentiallyhazard-
oussituation which, ifnotavoided,could result in
deathor seriousinjury.
indicates a potentially hazard-
ous situation which, if not avoided may result in
minoror moderateinjury.
used without the safety alert
symbol indicates, a potentially hazardous situa-
tion which, if not avoided may result in property
damage.
Readandfollow allsafetyinformationandinstruc-
tions.
!
WARNING
!
CAUTION
CAUTION
!

3
TRIMLINESCREENROOM
TRIM LINE SCREEN ROOM
INSTALLATION
APPLICATION:
The A&E Trim Line Screen Room is available in sizes to
correspondwiththevarioussizesofTrimLineAwnings.
TOOLSREQUIREDFORINSTALLATION:
Pencil 1/8 Drill Bit
Measuring Tape Center Punch
Phillips Screwdriver Hammer/Mallet
Drill (for Hook Stakes)
IMPORTANT: Read the entire installation procedure
before starting the installation.
TheDometicCorporationreservestherighttomodifyappear-
ances and specifications without notice.
INSTALLATION
During installation, care must be taken not to scrape and
damagethe panel and skirt.
1. InordertocorrectlymatchtheScreenRoomtotheright
sizeTrimLineAwning,youmustknowthelengthofthe
awning. See FIG. 1A.
TheA&ETrimLineScreenRoomconsistsof(1)continu-
ous panel for the front, sides and rear skirt.
Theabove-mentionedpanelandskirtaresecuredtothe
vehicle,theawningandtothegroundbymeansofhook
and loop fasteners, twist fasteners and hook stakes
(provided).SeeFIG.1C.
NOTE:Theinnerandoutersidesofallpanelscanbe
checked by looking at the hook and loop fastener
strips. The fastener strip on the front is on the
outside.
2. SetupawningforinstallationofTrimLineScreenRoom.
To facilitate accurate installation, vehicle should be
parkedonreasonablyflatground.
Openawningandinstallfrontsupportandsiderafterpole
as shown in FIG. 2
FIG. 1A
SELECTINGTHE
CORRECTSIZE
LENGTH
(AWNING SIZE)
FIG. 1B
FIG. 1C
FASTENER
STAKE
VEHICLE
SKIRTING
FRONT & SIDE
PANELS ARE ONE PIECE
SIDE OF
VEHICLE
FRONT
SUPPORT
SIDE RAFTER POLE
AWNING FABRIC
SIDE VIEW
FIG. 2
FIG. 3
Hook&Loop
FastenerSewnonTop
ofAwningFabric
andUnderValance
3. Afterawningissetup,removescreenroomfromstorage
bagandlineupinpositionwithawningasshowninFIG.
3.
4. Fastenfrontofscreenroomtofrontbyjoininghook&loop
fastenerstogetherundervalance.Pull side panels over
raftersand join tofabric on topof awning onboth sides.
5. Whenattachingscreenroom to awningatbag, pull bag
awayfromawningandbunchbagsothatscreenroomis
securelyattached toawning fabricinside ofbag.

4
TRIMLINESCREENROOM
WHEEL COVER
MOUNTING INSTRUCTIONS
1. Place the wheel cover in position to cover the wheel
opening and mark the locations of the button sockets.
2. With a 1/8" drill bit, pilot drill a shallow hole at each
markedlocationandinstallatwistfastener(providedin
plastic bag).
3. Install the wheel cover by snapping onto the twist
fastenersandturningfasteneronequarterturn.
4. Take the 3 inch pieces of hook and loop strip; remove
peel strip and stick them onto the screen room skirting
oppositethehookandloopstripsonthewheelcover(see
FIG.7).
FIG. 7
Hook &
Loop
Fasteners
7. Ifcamperdoesnothavecoversforliftermechanism,fold
screenroom flap around lifter as shown in FIG.5.
Tie straps attach
around support pole
Twist fasteners on each side
flap and on rear skirt.
Grommets
Skirt
Hook & Loop
Fasteners
FIG. 6
6. Flapsat rearofsidepanel on screenroomareto fasten
totentcanvasatliftermechanism. Pulltentcanvasflap
away from hook & flap strips. Secure screen room flap
to tent canvas using hook & loop fasteners sewn into
both. Secure tent flap to screen room flap as shown in
FIG. 4.
FIG. 4
FIG. 5
8. Align skirt at floor and wall of camper. Locate positions
of twist fasteners and mark with pencil. Drill 1/8" holes
and install twist fasteners.
9. Attach skirt to camper using twist fasteners just in-
stalled. Ifneeded,locatewheelskirtoverwheelwelland
installusinghook&loopfastenerstripsandtwistfasten-
ers.
10.Securebottomofpanelsbydrivingthehookstakesinto
thegroundthroughtheappropriategrommet.(SeeFIG.
6)
11.AttachskirttoScreenRoomwithhookandloopfasteners
sewn into room and skirt (see FIG. 6) Do not operate appliances venting into this
room enclosure with privacy panels closed.
At least one panel must be open for ventila-
tion when using appliances. Death or series
injury from Carbon Monoxide Poisoning
could occur if not operated properly.
WARNING
!