DORANI DORVT15 User manual

DORANI TOUCH 2 WIRE SERIES
SUPPLEMENTARY MODULES INSTALLATION MANUAL
DORVT15: Relay Module
Image 12.1 Connection
Device & Settings
Th s dev ce allows a secondary RELAY tr gger to be act vated w thout the need for an
add t onal door stat on. It also allows for a greater level of secur ty f requ red as
tr gger ng s done w th n the home.
Example: Door Stat on 1 - Call Release 1 = Pedestr an Gate, Release 2 = Dr veway Gate
A max mum of 1 Relay Module can be added nto the system.
Setting Dip Switches
The d p sw tch sett ngs on the rear need to be set as per the d agram (Sw tch 3 = ON)
Th s enables the Lock release for Door 1 Release 2 on the nternal mon tors.
Your nstallat on conf gurat on should be done to enable the system to operate n th s
manner.
POWER SUPPLY
(DORVT09)
BUS
IM DS
RELAY MODULE
(DORVT12)
BUS
IN OUT
As Per Door Statio
Co ectio s
Images 1.1, 1.2, 2.1
As Per Mo itor
Co ectio s
Images 1.1, 1.2, 2.1
If this Module is co ected to a
2 Door station System, Port C or
D o the 4 Bra ch Co troller is
used for the i put of the Relay
Module
Normally CLOSED
Commo
Normally OPEN
Grou d
12V 450mA Output
SW2 Switch 2 (programmi g)
SW1 Switch I put 1
Grou d
Relay
Contacts
Dip Switch
Setting On Rear
ON
1
2
3

Adjusting Time of the Relay Output
Default = 3 Seconds
1) Power Up Module – w th n 5 seconds Short S2 & GND for 3 Seconds (IN USE w ll
Flash)
2) Short S1 & GND for 3 Seconds (IN USE w ll go SOLID)
3) Short S2 & GND for t me per od des red 1 – 30 Seconds (IN USE w ll flash for t me
per od)
4) Release of S2 w ll save the sett ngs and ex t programm ng mode