Dorel Asia DA6504B4 User manual

Model No:
UPC CODE:
Lot number:
(TAKEN FROM CARTON)
_____________________________________
_______ / _______ / _______
Date of purchase:
DOREL ASIA
DA6504B4 (Walnut)
0-65857-16508-1
Crib
DO NOT RETURN PRODUCT TO THE STORE.
If a part is missing or damaged, contact our customer service
department. We will replace the part FREE of charge.
Tel #: [phone]
E-Mail: [email protected]
NEED HELP!
CALL US FOR ASSISTANCE
1-800-295-1980
DO NOT RETURN PRODUCT TO STORE
E-MAIL:[e-mail]

*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
The TODDLER BED or DAY BED is not intended for children under 15 months of age or over 50
pounds (22.7kgs).
If guardrails are used as the mattress containment means, guardrail(s) provided must be used to
avoid the formation of a gap between the mattress and the bed that could cause an entrapment
(when product is used as a TODDLER BED or DAY BED).
Never use plastic shipping bags or other plastic film as mattress covers because they can cause
suffocation.
Replace teething rail if damaged or loose (if teething rail is provided for this model).
CAUTION: ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27-1/4 INCHES BY 51-
5/8 INCHES (69CM BY 131CM) WITH A MINIMUM THICKNESS OF 4 INCHES (10CM) BUT
NOT EXCEEDING 6 INCHES (15CM).
Infants can suffocate in gaps between crib sides and a mattress that is too small.
Strings can cause strangulation! DO NOT place crib with a string around a child's neck, such as
hood strings or pacifier cords. DO NOT suspend strings over a crib or attach strings to toys.
To help prevent strangulation tighten all fasteners. A child can trap parts of the body or clothing on
loose fasteners.
If refinishing, use a non-toxic finish specified for children's products.
When child is able to pull to standing position, set mattress to lowest position and remove bumper
pads, large toys and other objects that could serve as steps for climbing out.
Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional
padding under an infant.
Stop using crib when child begins to climb out or reaches the height of 35 inches (89 cm).
To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to
sleep, unless otherwise advised by your physician.
DO NOT place crib near window where cords from blinds or drapes may strangle a child.
Read all instructions before assembling crib. KEEP INSTRUCTIONS FOR FUTURE USE.
E-MAIL: [email protected]
Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing
parts or sharp edges before assembly and frequently during use. Securely tighten loose bolts and
other fasteners. DO NOT use crib if any parts are missing, damaged or broken. Contact a customer
service representative at 1-800-295-1980 for replacement parts and instructional literature if
needed. DO NOT substitute parts.
WARNING
12345 Albert-Hudon Boulevard, Suite 100
Montreal, Quebec
Canada, H1G 3L1
You can also order parts by writing to the address listed below. Please include the product
model number, color and a detailed description of the part.
CUSTOMER SERVICE
CALL 1-800-295-1980
Customer Service Department No. 413
If you are missing parts or have any questions about this product, contact our customer
service representative first!
Failure to follow these warnings and assembly instructions could result in serious injury or death.

*
*
*
*
*
*
*
WARNING: Should this product become
damaged, and/or components are broken or
missing, DO NOT USE.
Estimated assembly time: 30 minutes.
Dust regularly with a soft, lint-free cloth to prevent soil build-up. A damp cloth may be used
occasionally to clean surface. Dry immediately. Do not use any abrasives that may damage
finish. Excessive exposure to sunlight and extreme changes in temperature and moisture can
damage wood furniture.
CARE AND CLEANING
MAINTENANCE
Check bolts/screws periodically and tighten them if necessary.
DOREL ASIA warrants its product to be free from defects in material and workmanship and
agrees to remedy any such defect. This warranty covers 1 year from the date of original
purchase. This warranty is valid only upon presentation of proof of purchase. This is solely
limited to the repair or replacement of defective furniture components and no assembly labor
is included. This warranty does not apply to any product which has been improperly
assembled, subjected to misuse or abuse or which has been altered or repaired in any way.
This warranty gives you specific legal rights and you may also have other rights which vary
from State to State.
LIMITED WARRANTY
Ensure all parts and components are present before beginning assembly.
Assemble on a soft, smooth surface to prevent damage to product finish.
NOTES
DO NOT use power tools.
CAUTIONS: Adult assembly required.
Assembly will require two people.
Phillips head screwdriver is not included.

1 2
3 4
5 6
7
Ø1/4" x 2-1/2"
Ø1/4" x 5/8"
SPRING WASHER
ALLEN KEY
16 PCS
1 PC
SHORT HEX SOCKET HEAD BOLT
SEMICIRCLE GASKET
2 PCS
MATTRESS SUPPORT BOLT
14 PCS
16 PCS
Ø6mm x 10mm x 1.2mm
4mm
28 x 15mm x 8mm
WOOD DOWEL
12 PCS
LONG HEX SOCKET HEAD BOLT
6 PCS
CRIB
DA6504B4
HARDWARE LIST
Ø10mm x 50mm
Ø1/4" x 3-1/8"

A B C
D E F
G H
1 PC
CRIB
DA6504B4
FRONT PANEL
1 PC
1 PC
LEFT SIDE PANEL
PARTS LIST
LEFT POST
1 PC
RIGHT POST
1 PC
GUARDRAIL
MATTRESS SUPPORT
1 PC
1 PC
RIGHT SIDE PANEL
BACK PANEL
1 PC

Insert the wood dowels (1) into the left and right side panels (C & D).
Attach the left and right posts (A & B) to the side panels (C & D) with short hex socket
head bolts (3) as shown.
Use Allen Key (6) to tighten the bolts.
CRIB
DA6504B4
STEP 1:

CRIB
DA6504B4
STEP 2:
Insert wood dowels (1) into the left side panel (C).
Attach the left side panel (C) to the back panel (E) with long hex socket head bolts (2) as
shown.
Use Allen key (6) to tighten the bolts.
Repeat this step to attach the right side panel (D) to back panel (E) as shown.

Attach the mattress support (H) to the left and right side panels (C & D) with mattress
support bolts (4) and spring washers (5). Use Allen key (6) to tighten the bolts.
NOTE: Do not fully tighten bolts. This will facilitate assembly in next step.
CRIB
DA6504B4
STEP 3:
INCORRECT-
Raised edge
should face down
-this photo shows
mattress support
is upside down.
INCORRECT-
Tabs on
corners of
mattress
support should
point up.
CORRECT
*Tabs to point UP.
*Flat surface of mattress support to face
up - mattress must sit on flat surface.

Attach the front panel (F) to left and right posts (A & B) with wood dowels (1) and short
hex socket head bolts (3) as shown.
Use Allen key (6) to tighten the bolts.
NOTE: Fully tighten all bolts installed in previous step.
NOTE: When the child is able to stand on his/her own, place the mattress support
at its lowest position.
CRIB
DA6504B4
STEP 4:

DAY BED ASSEMBLY INSTRUCTION: STARTING FROM SCRATCH
STEP 1: Follow steps 1 to 3 of the crib assembly instruction.
STEP 2: Follow steps 2 to 3 for the day bed assembly instruction located above (starting
from crib).
NOTE: When inserting bolts, turn clockwise until tighten. Then loosen 1/2-3/4 of a turn.
After crib is completely assembled, return to each bolt and tighten. Use wax or
soap on all bolts to facilitate assembly.
STEP 1: Detach the assembled front panel (F) from the side posts (A & B) with Allen key (6).
STEP 3: Attach the guardrail (G) (the molding should face down) to the side posts (A & B)
with short hex socket head bolts (3), semicircle gaskets (7), wood dowels (1)
and Allen key (6).
STEP 2: Move the mattress support (H) to the lowest position by unscrewing bolts (4)
with Allen key (6).
* The day bed is not intended for children under 15 months of age or over 50 pounds
(22.7 kgs).
* Any mattress used in this crib must be at least 27-1/4 inches by 51-5/8 inches (69cm by
131cm) with a minimum thickness of 4 inches (10cm) but not exceeding 6 inches (15cm).
DAY BED ASSEMBLY INSTRUCTION: STARTING FROM CRIB
CRIB
DA6504B4
WARNINGS:

FULL SIZE BED ASSEMBLY INSTRUCTION
(HEADBOARD AND FOOTBOARD ONLY)
CRIB
DA6504B4
DIAGRAM 2
IMPORTANT: Store unused parts of "crib", "day bed" or "full size bed" for future use.
ALWAYS STORE THE ASSEMBLY INSTRUCTIONS IN THE POUCH ATTACHED TO
THE MATTRESS SUPPORT (H).
BACK PANEL (E)
DIAGRAM 1
BACK PANEL (E)
FULL SIZE CONVERSION RAILS AND LEGS ARE NOT INCLUDED. DIAGRAMS
ARE FOR REFERENCE ONLY. BED RAILS MAY DIFFER FROM ILLUSTRATION.
STEP 1: Attach the full size conversion
rails (not included) to the back panel (E)
and posts (A & B).
STEP 2: Add the bed bar (not included).
A
B
FRONT PANEL (F)
FRONT PANEL (F)
A
B

CRIB
DA6504B4
CAUTION: This unit is intended for use only with the products
and/or maximum weights indicated. Use with other products
and/or products heavier than the maximum weights indicated
may result in instability or cause possible injury.
That's it ! You've finished assembling your CRIB.
Stop using crib when child begins to
climb out or reaches the height of 35 in.
(89 cm).
ANY MATTRESS USED IN THIS CRIB
MUST BE AT LEAST 27-1/4 INCHES
BY 51-5/8 INCHES (69CM BY 131CM)
WITH A MINIMUM THICKNESS OF 4
INCHES (10CM) BUT NOT
EXCEEDING 6 INCHES (15CM).
The DAY BED is not intended for
children under 15 months of age or over
50 pounds.
DO NOT RETURN PRODUCT TO THE STORE.
If a part is missing or damaged, contact our customer service
department. We will replace the part FREE of charge.
Tel #: [phone]
E-Mail: [email protected]
Fax #: [phone]
NEED HELP!
CALL US FOR ASSISTANCE
1-800-295-1980
DO NOT RETURN PRODUCT TO STORE
E-MAIL:[e-mail]
Maximum weight not to exceed 50
pounds when used as a crib.

MODEL #: DA6504B4
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE
PLEASE CONTACT CUSTOMER SERVICE REPRESENTATIVES AT THE FOLLOWING
NUMBERS SHOULD THERE BE ANY MISSING OR DEFECTIVE PART(S).
Request Date:
Name:
Shipping Address:
Street & Number:
City & State:
Zip Code:
Day Time Phone Number:
(including area code)
Date & Place of Purchase:
Part(s) description and quantity (Please be sure to list model number or SKN number):
Customer Service
Customer Service Representative Mailing Address:
Customer Service Department No. 413, 12345 Albert-Hudon Boulevard, Suite 100, Montreal, QC, Canada, H1G 3L1
Email: [e-mail]
Customer Service Phone Number 1-800-295-1980
Customer Service Fax Number 514-353-7819