Dragonfly DFM-RF-TRIG-12V User manual

DFM-RF-TRIG-12V
The DFM-RF-TRIG-12V sends UP/DOWN
commands to the Dragony™Filmscreen
from the 12V output of a component.
12V RF Wireless Trigger
3. Insert plug of wireless trigger into +5V - 12V DC
hole of device (typically a projector or receiver).
4. Screen should open (lower) automatically
when device is turned ON and close (raise)
automatically when device is turned OFF.
Projector
Off
Projector power
on-off button
2-Year Limited Warranty
This Dragony Accessory has a 2-Year Limited Warranty. This warranty includes parts and labor
repairs on all components found to be defective in material or workmanship under normal condi-
tions of use. This warranty shall not apply to products which have been abused, modied or disas-
sembled. Products to be repaired under this warranty must be returned to SnapAV or a designated
service center with prior notication and an assigned return authorization number (RA).
For Technical Support: 1.866.838.5052
Lower
Raise

Installation
1. Take 3V Battery (CR2430) positive side
up and insert in to battery slot.
2. a. Insert wireless RF/IR receiver into external
IR input of screen.
b. Insert a small pin into the programming
button hole insert. With the pin inserted,
depress the programming button and the
indicator light will ash repeatedly. The
programming instructions will be synced to
both devices and the program mode will end.
Once completed, the indicator light will stop
ashing and stay on.
(Positive side UP)
Wireless Converter (RF to IR ) 12V Wireless Trigger
Programming
Button
Indicator Light
Battery Battery Model: CR2430 (3v) Lithium
Transmitting Frequency: 868MHz
Modulation Method: RF
Pin Insert
Battery
Groove
RF to IR Receiver
Wireless 12V
Trigger