Draper FS405V User manual

10.1 TROUBLESHOOTING GUIDE
Note: Repairs should only be carried out by a qualified person.
Problem Possible Cause Remedy
Breaking blades. Wrong tension.
Over working blade.
Wrong blade application.
Twisting blade.
Adjust blade tension.
Reduce feed rate.
Use narrow blades for cutting
thin material, wide blades for
thicker material.
Avoid side pressure on blade.
Motor will not run. Defective cable or plug.
Defective motor.
Replace defective parts.
Consult your service agent.
Any attempt to repair this
motor may be dangerous
unless the repair is carried
out by a qualified service
agent.
Vibration. Increase mounting of saw.
Unsuitable mounting surface.
Loose table.
Refer to the mounting
instructions in this manual.
The heavier your work bench
is the less vibration.
A plywood work bench is not
as good as solid timber.
Tighten table locking knob.
Adjust table if necessary.
Blade runout – blade out of
line with arm motion.
Blade holders not aligned. Loosen screws holding blade
holders to arms. Adjust the
position of the blade holders
– tighten screws.

12. DISPOSAL
12.1 DISPOSAL
– At the end of the machine’s working life, or when it can no longer be repaired, ensure that it is
disposed of according to national regulations.
– Contact your local authority for details of collection schemes in your area.
In all circumstances:
• Do not dispose of power tools with domestic waste.
• Do not incinerate.
• Do not dispose of WEEE* as unsorted municipal waste.
* Waste Electrical & Electronic Equipment.