Draper CVS User manual

Please Note: These instructions are meant as a guide only.
They do not imply any responsibility on the part of Draper, Inc. for improper installation or faulty workman ship at the jobsite.
CAUTION
1. Over-tightening top cable can damage equipment and possibly cause injury.
2. Center of net will sag slightly. This is natural. Do not try to compensate by
over-tightening top cable. (See “Net Height” information below.)
3. Make sure proper parts and accessories have been shipped. Do not attempt to
install any accessories that are not intended for your Volleyball System.
4. Do not attempt to operate the winch by using an electric drill; hand crank only.
5. Please read the following installation guidelines thoroughly and follow them
carefully. Failure to do so may cause product to fall or otherwise fail, and
invalidates warranty.
Please Note: Custom products
/ installations may not be reflected by this
document. Call Draper, Inc. if you have questions about your installation.
If you have any difficulties installing or servicing your
CVS Volleyball System, call your dealer or Draper, Inc.
Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385
draperinc.com | 765.987.7999 | 800.238.7999
© 2020 All Rights Reserved | FORM: CVS_VB_Inst20
Combination Volleyball System
Highly maneuverable, volleyball system with infinite net height adjustment
INSTRUCTIONS
INSTALL ATION & OPERATION

Section 1 - Assembling Vertical Standards
1. Attach power winch assembly to one of the 3½" (89mm) O.D. upright tubes
and temporarily tighten near the center of the standard with hex wrench.
2. Attach cable anchor collar onto the other 3½" (89mm) O.D. upright tube
and temporarily tighten near the center of the standard with hex wrench.
3. Install one sliding adjustment collar on each upright tube. Make sure collar
is installed so guide pin is located on the narrow vertical channel.
4. Attach endcaps to both ends of standards.
5. Install vertical standards in floor sleeves (see VB_FloorSleeves_Inst for details).
6. Locate the center of the winch assembly 47" (1.19M) up from the playing surface and tighten screws with hex wrench.
7. Locate the center of the cable anchor collar 47" (1.19 M) up from the playing surface and tighten screws with hex wrench.
NOTE: It will be necessary to move winch and cable anchor collar when using CVS volleyball system for nets heights other than Mens
/ Womens Volleyball.
8. For initial set up, you will start by setting at MENS height. Position the center of the sliding adjustment collar approximately 1" (25mm) above the desired net
height or 8' 0-
5
/ 8 " (2.45M) above the playing surface. Make sure guide pin is in the narrow vertical channel and tighten hand knob to secure in place. Hand knob
should tighten so that it is fully inside wider vertical channel.
Section 2 - Attaching Net to Standards
1. Unroll net on floor between standards.
2. If not already in place, install ½" (13mm) fiberglass rods in
ends of net.
3. String net between standards by sliding looped cable
over pulley on sliding adjustment collar.
4. Unspool the 2" (51mm) nylon strap from power winch.
Hook one end of the top net cable in hook on belt.
Hook opposite end of top net cable to cable anchor collar
on the other standard.
NOTE: Make sure the cable is running cleanly through sheaves.
Section 4 - Tensioning the Net
1. Tighten net by turning winch handle clock wise. Measure
distance from playing surface to the top of net at center.
Rules allow net to be ¾" (19mm) higher at court sidelines.
2. Set net height to 7' 11
5
/ 8 " (2.43m).
3. Tie a loop in one end of the bottom net rope. Loop is usually at
end with cable anchor collar for convenience. Hook rope to
cable anchor collar (or power winch).
4. Insert the remaining end of bottom net rope into rope tensioner
and clip it to the power winch (or cable anchor collar).
5. Wrap 1" (25mm) wide net tension straps once
around standards and tighten using buckles.
NOTE: Winch incorporates a worm gear type
mechanism.
To loosen top cable, turn winch handle
counterclockwise.
5. Remeasure at center to ensure proper net height.
The Combination Volleyball System is
now set for regulation MENS volleyball.
TOP NET CABLE
FLOOR PLATE (2)
(Ordered Seperately)
3 ¼” (8.89cm) ID
FLOOR SLEEVE
501006
(Ordered Seperately)
ENDCAP
ENDCAP
Combination Antenna
and Boundary Marker
CABLE
ANCHOR
COLLAR
SLIDING
ADJUSTMENT
COLLAR
POWER WINCH
with
Folding Handle
SLIDING
ADJUSTMENT
COLLAR
½" (1.27cm)
fiberglass dowel rod (2)
ROPE
TENSIONER
2" (5.08cm)
NYLON STRAP
Combination Antenna
and Boundary Marker
CENTER of WINCH
CENTER of COLLAR
NET TENSION
STRAPS
NET TENSION
STRAPS
BOTTOM NET ROPE
TOP NET CABLE
BOTTOM NET ROPE
MENS &
WOMENS
47” (119.4cm)
ABOVE
PLAYING
SURFACE
NET
HEIGHT
3’ 3 3/8”
(1 METER)
1’ 9”
(53.3cm)
1’ 9”
(53.3cm)
NET
HEIGHT
3’ 3 3/8”
(1 METER)
MENS &
WOMENS
47” (119.4cm)
ABOVE
PLAYING
SURFACE
PLAYING
SURFACE
PLAYING
SURFACE
ADJUSTMENT COLLAR CABLE ANCHOR COLLAR POWER WINCH
ASSEMBLY
As A Set: C129.029 PN: C132.050
Figure 1
page 2 of 4
Combination Volleyball System

Official Net Heights for USVBA, NCAA, and NFSHSA (Volleyball)
VOLLEYBALL GIRLS BOYS
Grades 1-6 (Elem.) 6'1" (1.85m) 6'1" (1.85m)
Grades 7-9 (Middle School) 7' 4
1
/ 8 " (2.24m) 7' 4
1
/ 8 " (2.24m)
Grades 7-9 (Jr. High) \ 7' 4
1
/ 8 " (2.24m) 7' 11
5
/ 8 " (2.43m)
Grades 9-12 (Sr. High) 7' 4
1
/ 8 " (2.24m) 7' 11
5
/ 8 " (2.43m)
Collegiate & International 7' 4
1
/ 8 " (2.24m) 7' 11
5
/ 8 " (2.43m)
BADMINTON 5'1"
TENNIS 3'6"
Note: Regulation net heights are set at center of net.
Ends of net (at court lines) cannot exceed the regulation height
by more than ¾" (2 cm). Allow ¾" (2 cm) net sag at all settings.
Section 5 - Attaching Net Height Labels
Section 5.1 - Womens Volleyball Net Height
1. After the MENS position of sliding adjustment collar has been determined,
make a mark on the standard at the bottom edge of adjustment collar.
2. Loosen the adjustment collar and slide it down the post.
You may need to unwrap the top net tensioning strap.
3. Locate the net height labels . Align the bottom MENS line (see Fig. 2)
with the mark made in step 1 and apply the label in the wide
vertical channel. Both MENS and WOMENS net heights are
now marked on the post.
Section 5.2 - Badminton & Tennis Net Height Labels
The power winch, cable anchor collar and adjustment collars are all
designed to slide down to accommodate nets appropriate for
badminton and tennis (502110 -Tennis Net recommended).
1. Adjust the collars and power winch to the appropriate height for
badminton and mark the bottom edge of the adjustment collar.
2. Loosen the adjustment collar
and slide it down the post.
3. Align the bottom line on the
BADMINTON label with the mark.
4. Repeat steps 1-3 for Tennis
Section 6 - Safety Label
1. Attach the net strap safety label to
the interior curved surface of the
post IN CLEAR VIEW of the winch
operator.
BOTTOM
ALIGN WITH
MARK
CENTER
TOP
TOP NET CABLE
FLOOR PLATE (2)
(Ordered Seperately)
3 ¼” (8.89cm) ID
FLOOR SLEEVE
501006
(Ordered Seperately)
ENDCAP
ENDCAP
Combination Antenna
and Boundary Marker
CABLE
ANCHOR
COLLAR
SLIDING
ADJUSTMENT
COLLAR
POWER WINCH
with
Folding Handle
SLIDING
ADJUSTMENT
COLLAR
½" (1.27cm)
fiberglass dowel rod (2)
ROPE
TENSIONER
2" (5.08cm)
NYLON STRAP
Combination Antenna
and Boundary Marker
CENTER of WINCH
CENTER of COLLAR
NET TENSION
STRAPS
NET TENSION
STRAPS
BOTTOM NET ROPE
TOP NET CABLE
BOTTOM NET ROPE
MENS &
WOMENS
47” (119.4cm)
ABOVE
PLAYING
SURFACE
NET
HEIGHT
3’ 3 3/8”
(1 METER)
1’ 9”
(53.3cm)
1’ 9”
(53.3cm)
NET
HEIGHT
3’ 3 3/8”
(1 METER)
MENS &
WOMENS
47” (119.4cm)
ABOVE
PLAYING
SURFACE
PLAYING
SURFACE
PLAYING
SURFACE
Figure 2
page 3 of 4
Combination Volleyball System

500014 Volleyball Net 500016 Combination
Antenna and Boundary Marker
32'0" Net
4" Square netting
#36 Nylon cord (black)
1" wide polypropylene
tension straps with
tensioningbuckles
1
/4" dia. braided
white
nylon rope
1/2" dia. fiberglass dowel
3'33/8" (1 meter)
40'6" nylon coated
1/8" aircraft cable
3'0"
2"
page 4 of 4
Combination Volleyball System