Dreiha Coolingbox 45 lr User manual

Important safety information

Product Features

Product Structure

Function and Operation

Battery Operation

Cleaning and Storage

Warranty & Maintenance

Troubleshooting

Technical lnformation

Instrucciones de seguridad

Especificaciones de Producto

Estructura del Producto

Función y funcionamiento

Operación de la batería

Limpieza y almacenamiento

Garantía y mantenimiento

Solución de problemas

Información Técnica

Wichtige Sicherheitsinformationen

Produktbeschreibung

Produktaufbau

Handhabung

Batteriebetrieb

Reinigung

Garantie und Wartung

Fehlercodes

Technische Daten

Instrukcje bezpieczeństwa

Opis Produktu

Struktura produktu

Funkcje I działanie

Zasilanie bateryjne

Czyszczenie i Przechowywanie

Gwarancja I Konserwacja

Rozwiązywanie problemów

Dane techniczne

Instruções de segurança

Descrição do Produto

Identificação das Partes

Funções e Configuração

Funcionamento da Bateria

Limpeza e Armazenamento

Garantia e Manutenção

Perguntas Frequentes (FAQ)

Informações Técnicas

CoolingBox App Control

Dreiha Fridge Slide · CBX-SB

4-5

5-6

9-10

10-11

14-15

15-16

19-20

20-21

24-25

25-26

Content Contenido Inhalt Content Conteúdo

DANGER! Safety instruction: Indicates a hazardous situation that, if not avoided, will result in death or serious injury.

WARNING! Safety instruction: Indicates a hazardous situation that, if not avoided, could result in death or serious injury.

CAUTION! Safety instruction: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.

NOTICE! Indicates a situation that, if not avoided, can result in property damage.

NOTE! Supplementary information for operating the product.

Safety instructions!

• Observe all applicable laws and regulations.

• Only transport the device in an upright position

• Be careful during installation and maintenance. Avoid operating errors to prevent electric shocks, accidents.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance

in a safe way and understand the hazards involved.

• Cleaning and maintenance of the user must not be carried out by children without supervision.

Only qualified and certified personnel, i.e. electricians according to DIN EN 501100-1 (VDE 0105-1), may be used for all work, e.g.

modification, installation, operation, maintenance, troubleshooting, commissioning and repair on the fridge unit.

Risk of Death by Electric Shock

• If the device is visibly damaged, it must not be put into operation.

• If the connection cable is damaged, it must be replaced by a qualified person in order to avoid hazards.

• Repairs to this device may only be carried out by qualified personnel.

• Failure to do so may result in serious hazards.

• When setting up the device, make sure that the connecting cable is not pinched or damaged.

• Do not position portable multiple sockets or portable power supplies at the rear of the device.

Risk of Explosion & Risk of Fire

• Do not store explosive substances such as spray cans in the device.

• When setting up the device, ensure that the connection cable is not pinched or damaged.

• Keep the ventilation openings on all sides free, make sure that there is sufficient ventilation for built-in constructions.

• Do not use mechanical devices or other aids to speed up the defrosting process.

• Do not damage the cooling circuit.

Risk of Health

• Check beforehand whether the cooling capacity is sufficient for your application and whether it meets the requirements for

cooling your food or medication.

• Food may only be stored in the device in its original packaging or suitable containers.

• If the appliance lid remains open for a long period of time, the temperature in the cooling compartments may rise sharply.

• If you do not use the device for a longer period of time, please switch it off. Defrost the unit completely.

• Clean and dry all surfaces thoroughly and leave the lid open.

• Regularly clean the surfaces that come into contact with food.

Important safety information

Read this manual thoroughly before first use, even if you are familiar with this type of product. The safety precautions contained herein

reduce the risk of fire, electric shock, and personal injury when followed correctly. Keep the manual together with the proof of purchase and

the carton in a safe place for future reference.

The manufacturer is not liable for damage resulting from improper use or incorrect operation.

Failure to observe these safety instructions may result in serious injury or even death!

WARNING

CAUTION

Product Features

Product Structure

• High-efficiency DC compressor and conversion module.

• CFC free and great heat insulation.

• Lithium battery recharged by solar (12~50V), DC12/24V or AC 100~240V (using the adapter).

• Fast cooling to -20ºC/-4ºF (based on 25ºC/77ºF room temperature).

• LCD digital display for temperature setting.

• Dual compartments with individual temperature control.

• Three stage battery protection system prevents vehicle run out of battery.

• Specific parts: wire storage baskets, interior drain plug, oversize wheels and telescoping handle, wire storage baskets, detachable

battery, cupholder door, interior LED light.

NOTE!

• There are buttons on both sides of the telescoping hand, press them at the same time to pull the rod.

• Removable battery: press left and right to remove/insert the battery, the battery has a certain weight, it is recommended to hold it

with your hand and take it out gently.

• The cutting board can be moved by turning the knob on the top cover, it is suggested to clean and dry it after every use.

• Power supply: connect to 12V/24V DC power, 100~240V AC power (using the adapter), or use back-up lithium battery which can be

recharged by solar (12~50V).

• Display Screen initialization: connect to the power supply, the buzzer will make a long beep, and the display will be on for 2 seconds

then enter the normal operating mode.

• Power On/Off: long press for three seconds to switch ON/OFF.

• Function unlock: the panel will be locked automatically when stop pressing any button within 20 seconds, long press at the

same time for 2 seconds to unlock.

• Temperature Setting: under the running state, long press and at the same time for three seconds to switch ON/OFF the left

compartment, long press and at the same time for three seconds to switch ON/OFF the right compartment, two compartments

cannot be switched off at the same time.

When both left and right compartments are set in running state, press or to enter left compartment temperature setting,

press to increase temperature, press to decrease temperature, and press to switch left/right compartment. The setting will be

saved after stop operating for four seconds (Note: the temperature displayed is the current temperature of the compartments, it’ 11 take a

while to reach the set temperature.)

• Temperature setting range: -20~20ºC (-4~68ºF).

• Cooling Mode: under the running state, press to switch MAX (fast cooling) and ECO (Energy saving Mode). (*Factory setting is MAX.).

Function and Operation

• USB output: +SV DC/lA, suitable for small devices like mobile phones, tablets, etc.

• Temperature Unit Setting: switch off the fridge, long press for three seconds until E1 displays, then switch to E5 by pressing again.

Under E5 mode, press or to select Celsius or Fahrenheit. (*Factory setting is ºC.)

• Reset: switch off the fridge, long press for three seconds until E1 displays, under E1 mode, long press at the same time until the

screen displays as below:

*Note: Except E5, other E settings are used for factory maintenance, reset it if you operate the setting mistakenly.

• Battery Protection Mode: under the running state, long press for three seconds until screen flashes, then press again to select

protection mode H(High), M(Middle) and L(Low) (*Factory setting is H.)

Due to the different output voltages between vehicles, H should be set when the product is connected to car power, and M or L should

be set when it is connected to a portable battery or other back-up battery.

The battery gear should be set from H to M or from M to L if there is a voltage protection code Fl shown on the panel. The battery gear

should be set to H if the product keeps working after turning off the car engine, or the product may drain the battery.

MODE / INPUT DC 12V DC 24V

CUT OUT CUT IN CUT OUT CUT IN

L 9.0V 10.9V 21.3V 22.7V

M 10.1V 11.4V 22.3V 23.7V

H 11.1V 12.4V 24.3V 25.7V

• Reference voltage:

• Recommended temperaturefor common food:

*the voltage is theoretical value, there may be a deviation in different sceneries.

Battery Operation

The refrigerator can be connected to 12V/24V DC power, 100~240V AC power, or use backup lithium battery if DC/AC power are not

available. The battery will also be charged simultaneously when the fridge is connected to DC/AC power.

• Battery charging: lf you want to charge the battery separately, switch off the refrigerator and connect the battery to 12V/24V DC

power, 100~240V AC power or solar (12~50V) (it is suggested that connect to AC power first, after charging 30%, other charging methods can

be used).

When the battery is charging, the power indicator turns green, and the four blue battery indicators will show the charging status in a

marquee manner; when the battery is fully charged, the power indicator will turn off, the battery indicators are always on.

Battery bank:

Model No.: FSAK-002

Battery Capacity: 15600mAH

Rated Voltage: 11.lV

Charging Limited Voltage(DC): 12.6V

Charging Limited Current(DC): 3A

Warning: do not disassemble the battery.

NOTICE!

Do not charge the refrigerator with DC12Vand solar at the same time, W otherwise the refrigerator wouId be damaged!

• Battery ON/OFF: Long press the switch button of the battery to turn on/off. When the battery is off, press the switch button to

display the charging status (it will go out automatically after 3 seconds.)

Note:

• When the battery is not fully charged with the adapter or solar, it can’ t be turned off;

• When the power indicator is green, it means charging; when the power indicator is blue, it means discharging; when the power

indicator is off, it means the battery is fully charged.

• lf the refrigerator won’ t be in use for a long time, fully charge the battery and turn it off.

• Battery power saving: lt is recommended to charge the refrigerator before your departure. Put food and beverages in the refrigerator

and cool them to a proper temperature, which will make the lithium battery last longer and save energy. The battery output can be

disconnected by unplugging the battery or turning off the battery to prevent self-discharge.

• lnstructions for solar charging: When using solar panel to charge the battery, place the refrigerator in a cool place to avoid

overheating that would cause malfunction

of the refrigerator. The battery icon on the display will show the charging status when it is charging.

The charging input power should be higher than the working power of the refrigerator (about 40-45W), or press the power button to

make the refrigerator enter the stand by state, otherwise the battery will not be able to charge. lt is recommended to use a l00W solar

panel.

• lnstructions for in-vehicle use:

Engine start: select H, M or L mode (refer to Page 3 Battery Protection), and use car port power to operate the refrigerator.

Engine flameout: When using the car battery to charge, most cars will stop power supply after the engine is turned off, while sorne cars

will continue to supply power. At this time, the battery protection should be adjusted to H, otherwise the car battery may be exhausted,

resulting in insufficient power to start the car.

Solar panel (SOLAR) charge connection:

Insert the solar charge cable into

the refrigerator’s “SOLAR” terminal.

Max Solar Input Voltage: 50V

Max Solar Input Current: 10A

Discharge time( ECO and L mode)

Refrigeration About 4 hrs

Freezing About 2 hrs

(Not included in the package)

Defrosting:

Humidity can form frost in the interior of the cooling device or on the evaporator,

which will affect the cooling performance. Defrost the device regularly to avoid this.

• Switch off the device.

• Take out the contents of the device.

• Keep the lid open.

• Remove the cover and drain from the hale.

• Wipe off the defrosted water.

Never use hard or sharp tools to remove ice or to loosen objects which have a frozen in place.

Cleaning:

• Unplug the device first to avoid electric shock.

• Use wet cloth to clean the device and dry it.

• Remove the cover and drain from the hale at the bottom of the device.

• Do not soak the device in water and do not wash it directly.

• Do not use abrasive cleaning agents as these can damage the device.

Storage:

lf the device will not be in use for a long time, please follow the steps:

• Turn off the power and remove the plug.

• Remove ali the items stored in the device.

• Remove the cover and drain from the hale, wipe off excess water with a soft rag.

• Leave the lid slightly open to prevent odors from forming.

• Put the device in a cool and dry place.

Cleaning and Storage

Issues Suggestions

Refrigerator does not work. • Check if the switch is on.

• Check if the plug and socket are connected well.

• Check if the fuse has been burnt.

• Check if the power supply is malfunctioned.

• Switching on/off the fridge frequently may cause start delay

of the compressor.

Refrigerator compartments are too warm. • The door is opened frequently.

• A large amount of warm or hot food was stored recently. Wait for

the refrigerator to reach its selected temperature.

• The refrigerator has been disconnected for a period of time.

Food is frozen. • The temperature was set too low, please increase the temperature.

There is a "water flow" noise from inside the fridge. • lt’ s a normal phenomenon, caused by the flow of refrigerant.

There are waterdrops around the refrigerator

casing or door gap.

• lt’ s a normal phenomenon, the moisture will condense to water

when it touches a cold surface of the refrigerator.

The compressor is slightly noisy when starting. • lt’ s a normal phenomenon, the noise will be reduced after the com-

pressor works stably.

Code F1 displayed. • Possible cause: low voltage to fridge.

• Adjust the battery protection from H to M or from M to L.

Code F2 displayed. • Possible cause: condenser fan is overloaded.