dreo DR-HTF008 User manual

DREO
Tower Fan
USER MANUAL
0000000000000

Thanks for
Choosing
DREO!
Your support means the world to us. We
hope you enjoy our product as much as
we did creating it.
¢ © © @Dbreo

CONTENTS
IMPORTANT SAFETY
INSTRUCTIONS
1-2
ASSEMBLING YOUR
TOWER FAN
3-5
KNOWING YOUR
USING YOUR TOWER
TOWER TOWER FAN
FAN
67 8-11
CLEANING TROUBLESHOOTING
AND MAINTENANCE
12-13 14
DREO CUSTOMER FCC STATEMENT
CARE
15 16

IMPORTANT SAFETY
INSTRUCTIONS
READ AL CAUTIONARY
MARKINGS ONTHE APPUIANGE Do not coverthe Do not use the fan
AND SAFETY INSTRUCTIONS airinletand outlet near flammables
IN THE USER MANUAL BEFORE while in operation. and combustibles.
USE
General Safety
Children shall not play with the appliance. Cleaning and maintenance shall
not be performed by children without supervision.
N Use the appliance as described in the user manual only. Any other use
not recommended in the user manual may cause fire, electrical shock, or
personal injury.
w This appliance can be used by children aged above 8 years and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction
concerning use of this appliance in a safe way and understand the
hazards involved.
Operation Safety
1. Place the appliance on a flat, dry surface before use.
2. Do not immerse in water and any other liquids.
3. Do not use the appliance until the base is installed.
4. Do not insert your fingers, pencil and any other objects into the grilles
while in operation.
5. Do not dismantle, repair, or modify. All servicing should be performed by
qualified personnel.

Electricity Safety
1. Make sure that the voltage of your electricity supply is the same as that
indicated on the appliance.
Always unplug before cleaning or leaving the appliance unused for a long
period of time. Keep your hands dry when plugging/unplugging.
n
w Do not operate any fan with a damaged cord o plug. Discard fan or return
to an authorized service facility for examination andor repair.
I . Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be
tripped over.
WARNING: To reduce the risk of fire or electric shock, do not use this Fan
with any solid-state speed control device.
o
o
This appliance employs overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
and check the appliance. If the replacement fuse blows, a short-circuit
may be present and the appliance should be discarded or returned to an
authorized service facility for examination and/or repair.
~ This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way, If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not attempt to
defeat this safety feature.
FOR HOUSEHOLD USE ONLY READ
AND SAVE THESE INSTRUCTIONS
Gentle Reminder: Specifications
Check
the
appliance
reguiarly
Model
DRHTFOOT
and refer to TROUBLESHOOTING
or contact our customer support Input AC 120V 60Hz
if it shows any of the following
S5 Rated Power 50w
- Power cord or plug is damaged,
- Loud noise, unusual smell o excessive heat. Battery Type CR2025 3V

ASSEMBLING
YOUR TOWER FAN
Assembly Instructions
When using the appliance for the first time, remove the wraps and attach the
parts by following the steps below.
Arched Arched
@ e Sueeor @
Keep the base halves in a
crossed position, then hook
the arched cutout on one half
onto the arched support on
the other half.
Press down on edges to click two Run the cord through the center
base halves together. hole.

Fit the base onto the bottom of Rotate the base counterclockwise
the fan by aligning the arrows to lock in place.
on the underside.
CAUTION
+ Do not operate the tower fan if
the base has not been installed.
* Make sure to thread the cord
through all rear cord keepers.
Thread the cord through all
REAR cord keepers and put the
fan upright.

Package Contents
Control
an
Panel
Air Outlet
Base
Power & Plug
LED Display
Quick start
‘Guide
Remote Control
(battery included)
Carry
Handle
— Airinlet

KNOWING YOUR
TOWER FAN
Control Panel
()
©
©)
Power Button
- Turn power orvoff
Mode Button
Switch between NormalNatural/Sleep/Auto Mode
Fan Speed Button
Adjust airflow volume (1-6 levels)
Timer Button
Select to set a timer (0-12h)
Oscillation Button
- Adjust airflow direction

LED Display
20
=
Normal Mode
7
Natural Mode
S
Sleep Mode
AUTO
AUTO Mode
TIMER
Il
=,
Fan Speed/ Timer Hour
°F
Temperature
S il
Fan Speed

USING YOUR
TOWER FAN
General Operations
Working Modes
Sleep Mode
(Mute Auto On)
Fan speed decreases every
30 minutes.
Speed decreases by two
levels at most and will remain
constant if at level 1:
For level 6: 6~5+4
For level 5: 5+4=3
For level 3: 3+2-+1
For level 2: 21
For level 1: 1
Press (©) toturn on, and &)
to choose a working mode.
Press (%) to adjust the
airflow volume.
press © to change the
airflow direction.
Press @) to set a timer.
Press (O to turn off the
tower fan. 0000
Auto Mode
Fan speed adapts to the
ambient temperature.
Normal Mode
Fan runs at the constant speed.
Natural Mode
Fan runs at alternating speeds.
R

Additional Features
g
Mute (remote control only)
Press to turn on/off the button sounds.
Speed/Temp Switch (long press)
The display shows the fan speed by default. Long press
the Mode button to switch speed to temperature.
Timer
When the fan is ON, press the Timer button repeatedly
to set a timer (-12h). When the timer ends, the fan will
stop running automatically. To cancel, set the timer to O
hour.
Note: Display will return to fan speedtemperature after 10 seconds.
Memory
If the fan stays connected to the electrical outlet after
turning OFF, the fan will operate under the previous
settings (except timer setting) when turned ON again.
Display Auto Off
- Display turns off after 1 minute (after 5 seconds in
sleep mode).
- Wake up the display with any button.

Getting the Most out
of Your Tower Fan
1. Remove any tall obstacles that
might block the airflow from the fan.
2. Combine with your AC unit to get
cooler air throughout the room.
3. Position the tower fan closer to
you to get more direct airflow.
4. Place a bucket of ice in front of
the fan for an extra cooling boost.
Remote Control
Decrease Fan Speed —- +
Power Indicator
Power
Increase Fan Speed

Battery Replacement
@ Press the locking button to pop
out the battery holder.
@ Replace with the same battery
type with the (+) side facing up.
@© Push in the holder until securely
locked into place.
Note: If the indiicator on the remote
control doesn't turn on any more,
please consider replacing the
battery.
WARNING
Chemical Burn Hazard. Keep batteries away
from children.
This product contains a lithium buttorvcoin cell battery. If a new or
used lithium buttoncoin cell battery is swallowed or enters the body,
it can cause severe internal burns and can lead to death in as little
as 2 hours. Always completely secure the battery compartment. If
the battery compartment does not close securely, stop using the
product, remove the battery, and keep it away from children. If you
think batteries might have been swallowed or placed inside any part
of the body, seek immediate medical attention.
The cells must be disposed of properly, including keeping them
away from children. Even used cells may cause injury.

CLEANING AND
MAINTENANCE
QNN
Outer Surface
Gently wipe off the dust with a soft,
dry cloth.
Grilles & Blades
Remove the dust using a vacuum or
\alr duster.
Base
The base can be disassembled in
reverse order of assembly.
CAUTION
1. Always unplug the fan before any cleaning or maintenance
to avoid the risk of fire, electric shock, or injury to persons.
2. Do not immerse in water or get water inside the motor
housing.
3. Do not use any chemical agents when cleaning the fan.
4.Store in a cool, dry place and cover it to protect from dust.

User Servicing Instructions (Fuse)
This appliance features a fused safety plug that protects against overload or
short-circuit situations. If the fuse blows, please cut off power and follow the
below instructions or consult a qualified electrician.
Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
Open fuse cover. Slide open fuse access cover on top of attachment
plug towards blades.
Remove fuse carefully. Push the fuse from the other side to remove
the fuse.
Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
WARNING
Risk of fire. Do not replace attachment plug. Contains a
safety devicelfuse) that should not be removed. Discard
product if the attachment plug is damaged.

TROUBLESHOOTING
My fan won't turn on!
1. Make sure that the cord is connected to a powered outlet and the
mains voltage corresponds with the voltage indicated on the fan.
2. Check if the fuse has blown. If the fuse has blown, please refer to
page 13.
My fan is shaky and wobbling!
1. Place the fan on a flat, level surface.
2.Incorrect installation might also cause shakiness. Please refer to
the assembly instructions in page 3-4. Note that the power cord
must be run through all three keepers.
My fan is making vibration and noise!
1. Place the fan on a flat, level surface.
2. Be sure not to insert anything into the air inlet and outlet.
If your problem is not listed o still persists, please contact our
Customer Support (see page 15)

DREO CUSTOMER
CARE
Default 12-Month Warranty
This appliance is covered by Dreo warranty for 12 months from the date of
its original purchase.
Extend Your Warranty
Extend your warranty by registering your new appliance on our website
hi r rrant
The warranty will not apply in cases of:
. Accident, misuse, o repairs performed by unauthorized personnel.
2. Any unit that has been tampered with or used for commercial purposes.
3. Normal wear and tear of wearable parts.
4. Use of force, damage caused by external influences.
5. Damage caused by non-observance of the User Manual, e.g. connection
to an unsuitable mains supply or noncompliance with the instructions.
Partially or completely dismantled appliances.
Defects caused by or resulting from damages from shipping or from
repairs, service, or alteration to the product or any of its parts that have
been perform ed by a repair person not authorized by Dreo.
No
We can only provide after-sales service for products that are sold by Dreo
or Dreo authorized retailers and distributors. If you have purchased the
appliance from a different place, please contact your seller for return and
warranty issues.
@ [phone] @ supportedreo.com @ www.dreo.com
Mon - Fi, 00 am-5:00 pm PSTPDT

FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a
Consumer ISM equipment, pursuant to Part 15 of the FCC Rules.These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and,if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
“Please note that changes or modifications of this product is not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.”
“If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
~Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
~Consult the dealer or an experienced radio/TV technician for help.
@ www.dreo.com . ('I'b
Shenzhen Hesung Innovation Technology L ’ us
Co, LTD e
Intertel
9 26F, Bidg A7, Creative City, Shenzhen, China MADEINCHINA 5020677
Rev_1.3_EN

www.dreo.com
DR-HTFO08
Looking for help?
Contact us to get expert support.
@ supportedreo.com @ [phone] @ www.dreo.com
Mon - Fr, 9:00 am-5:00 pm PSTPDT